Other Name: Latch Assembly-Front Side Door; Door Lock Actuator Motor; Door Latch Assembly; Door Lock Actuator; Door Lock; Latch Assembly; Lock; Latch; Latch, Front Side Door; Latch, Door Lock
Position: Front Driver Side
Replaced by: 13546477
Fits the following GMC Models:
Canyon | 2023 | AT4, AT4X, Denali, Elevation | 4 Cyl 2.7 L GAS
Q: How to replace the rear side door lock actuator on GMC Envoy?
A: First remove the door trim panel and then the water deflector together with the Door Latch Assembly to access the rear side Door Lock Actuator. There are two screws which maintain the actuator in place to the lock. Lift the actuator away from the latch simultaneous to its rotation which disengages the rubber Bumper from the latch before removing the actuator from the post. First install the rubber Bumper on the latch then direct the actuator in the direction of the latch while fully engaging the rubber Bumper. The installation requires that the primary gear tooth of the actuator should lock into position with the equivalent tooth on the latch system. The top portion of the latch accepts the actuator for mounting before you fasten it with two screws which need to be tightened to 0.75 n.m (6 lb in). The lock installation ends with fitting the door, then adding back the water deflector and the door trim panel.
Q: How to replace the rear side door lock actuator on GMC Acadia?
A: The replacement of the rear side Door Lock Actuator requires you to first eliminate the door trim panel and water deflector along with the Door Latch Assembly. Obtain the two screws which fasten the actuator to the lock. After lifting the actuator while rotating it away from the latch the rubber Bumper will free itself from the latch and the actuator should be removed. You should start the installation by placing the rubber Bumper onto the latch before directing the actuator toward it to create complete rubber Bumper engagement. Install the actuator above the latch only when the first gear tooth alignment creates proper interlock between the actuator and latch teeth. Secure the actuator to the lock through installing its two screws before tightening them until they reach 0.75 n.m (6 lb in). You should put the lock back into the door while adding the water deflector and door trim panel.
Q: How to Remove and Replace a Front Door Lock Actuator on GMC Sonoma?
A: You must start the Door Lock Actuator replacement by taking out the door trim panel and then the water deflector and the Door Latch Assembly. The lock actuator needs its 2 holding screws removed for successful removal from the latch. Disengage the rubber Bumper from the latch by rotating the actuator simultaneously along with a lift motion. Afterwards remove the actuator off the latch. You need to mount the rubber Bumper to the latch before turning the actuator towards the latch to confirm complete engagement of the rubber Bumper with the latch. The proper operation requires first teeth alignment between actuator and latch gears before installation. Secure the actuator on top of the latch by following the provided fastener notice to complete installation using 2 screws while tightening them to 0.75 n.m (6 lb in). Replace the latch into the door and then install the water deflector and the door trim panel.