Disconnect the negative
Battery Cable before removing the air cleaner outlet resonator, for changing the generator for a 4.3l engine. Then remove the
Drive Belt together with removing the engine wiring harness clip from the A/C Compressor/condenser hose bracket and removing the A/C Compressor and condenser hose bracket bolt. Disengage heater outlet hose clamp bolt at the generator bracket, release generator electrical connector from the engine wiring harness, then reposition the boot on engine wiring harness. Unfasten the engine wiring harness nut from the generator and the engine wiring harness lead from the generator stud. Then remove the generator bolts and reset the heater outlet and the A/C Compressor/condenser hoses to take out the generator from the generator bracket. For installation, position the generator into the generator bracket and adjust the heater outlet and A/C Compressor/condenser hoses per your requirement. Mount the generator bolts and snug them up tight using a 50 n.m (37 lb ft) tightening torque. Connect the lead of the engine wiring harness to the generator stud and fasten the engine wiring harness nut to the generator, tightening to 9 n.m (80 lb in). Put on the engine wire harness boot over the generator stud & hook the engine wiring harness electric connector to the generator. Mount the heater outlet hose clamp bolt at the generator bracket, securing at 25 n.m (18 lb ft), then the A/C Compressor and condenser hose bracket bolt at the same torque. To reinstall the engine wiring harness clip to the A/C Compressor/condenser hose bracket as well as the Drive Belt, reinstall the air cleaner outlet resonator and reconnect the negative Battery Cable.