Make sure this part fits

GM 26081831
Pipe Kit, Passenger Side

2001-2006 GM

Customer Questions & Expert Answers (12)
GM 26081831 Pipe Kit, Passenger Side
  • Part Description
    Pipe Kit, Steering Gear; Power Steering Hose
  • Position
    Passenger Side
  • Manufacturer
    General Motors
  • Manufacturer's Notes
    This part is discontinued.
Make sure this part fits
  • Vehicle Fitment

    Year Make Model Trim Engine
    2002-2006 Buick RendezvousCX, CX Plus, CXL, CXL Plus, Ultra6 Cyl 3.4 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L GAS
    2005-2006 Buick TerrazaCX, CXL6 Cyl 3.5 L GAS, 6 Cyl 3.9 L GAS
    2005-2006 Chevrolet UplanderBase, LS, LT6 Cyl 3.5 L GAS, 6 Cyl 3.9 L GAS
    2002-2005 Chevrolet VentureBase, LS, LT, Plus, Value, Warner Bros.6 Cyl 3.4 L GAS
    2002-2004 Oldsmobile SilhouetteGL, GLS, Premiere6 Cyl 3.4 L GAS
    2001-2005 Pontiac AztekBase, GT, Rally6 Cyl 3.4 L GAS
    2002-2006 Pontiac MontanaBase, SV66 Cyl 3.4 L GAS, 6 Cyl 3.5 L GAS, 6 Cyl 3.9 L GAS
    2005-2006 Saturn Relay2, 36 Cyl 3.5 L GAS, 6 Cyl 3.9 L GAS
    Warning: California's Proposition 65
  • Customer Questions & Expert Answers

    Q:
    Can you help me check if this 26081831 is the right part for my car? Posted by ChevyPartsGiant Specialist
    A:
    Please Select Your Vehicle model to see if part number 26081831 is suitable before ordering.
    Posted by ChevyPartsGiant Specialist
    Q:
    What should be done after supporting the rear of the frame for the 2005 Buick Terraza? Posted by Customer
    A:
    Remove the frame rear bolts and lower the frame to gain clearance.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Power Steering Hose
    Q:
    What is the torque specification for connecting the cooler pipe to the steering gear for the 2005 Buick Terraza? Posted by Customer
    A:
    27 Nm (20 ft. lbs.).
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Power Steering Hose
    Q:
    What should be done with the wiring harness for the 2006 Buick Rendezvous? Posted by Customer
    A:
    Disconnect the wiring harness from the cooler bracket studs and remove the cooler pipe bracket retaining bolts.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Power Steering Hose
    Q:
    What are the final steps after reinstalling the frame for the 2006 Buick Terraza? Posted by Customer
    A:
    Remove the utility stand, reconnect the intermediate shaft to the steering gear, lower the vehicle, and connect the power steering pressure hose to the pump, tightening the fitting to 27 Nm (20 ft. lbs.).
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Power Steering Hose
    Q:
    What should be removed after raising for the 2003 Buick Rendezvous? Posted by Customer
    A:
    The right side engine splash shield and the power steering gear heat shield.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Power Steering Hose
    Q:
    What should be done after lowering the right side of the frame and powertrain for the 2004 Buick Rendezvous? Posted by Customer
    A:
    Uncap the hoses, pipes, and pump, then connect the power steering reservoir inlet hose to the power steering pump and the power steering reservoir return hose to the power steering pipe.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Power Steering Hose
    Q:
    What should be done after removing the pipe/hose from the stud for the 2005 Buick Rendezvous? Posted by Customer
    A:
    Raise and support the vehicle, then remove the front right tire and wheel along with the right side engine splash shield.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Power Steering Hose
    Q:
    What is the first step to replace the Steering Gear Pipe Assemblies/O-Ring seals for the 2002 Buick Rendezvous? Posted by Customer
    A:
    First, loosen both cylinder line fittings on the cylinder end of the gear assembly and both fittings on the cylinder line assemblies at the valve end of the gear assembly.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Power Steering Hose
    Q:
    What is the first step in the installation process for the 2006 Chevrolet Uplander? Posted by Customer
    A:
    Install the inlet hose.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Power Steering Hose
    Q:
    What should be done after installing the inlet hose for the 2002 Chevrolet Venture? Posted by Customer
    A:
    Raise and support the vehicle again.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Power Steering Hose
    Q:
    What is the first step in the installation process for the 2005 Chevrolet Uplander? Posted by Customer
    A:
    Install the inlet hose.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Power Steering Hose
    If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

OEM GM Pipe Kit, Passenger Side 26081831 Designed for Proper Fit and Performance

Original OEM GM parts deliver superior quality and meet all performance standards needed for optimal automotive operation. The authentic part identified by 26081831 Pipe Kit, Passenger Side is available in the market under the name GM Power Steering Hose. This genuine product has a full warranty coverage from the manufacturer available at all authorized GM dealers throughout the United States. This part 26081831 Pipe Kit, Passenger Side fits certain Chevrolet Uplander, Venture models, as well as Buick Rendezvous, Terraza. Additionally, it is compatible with Pontiac Aztek, Montana and Oldsmobile Silhouette models.
The original GM component designated by manufacturer part number 26081831 maintains top performance when functioning as the Pipe Kit, Steering Gear; Power Steering Hose unit at its Passenger Side. The component 26081831 is constructed from durable material and its dimensions span 18.2 x 3.1 x 1.5 inches while weighing 0.60 Pounds. The Direct Replacement component is ready in New condition to ensure full compatibility with your vehicle system. This component receives the designation of Pressure Line; Line Kit; Line; Pipe Kit, Hydraulic Steering Gear Pressure; Pipe Kit, Steering Gear Oil Pressure. The part 26081831 has available replacement options. GM manufacturer provides a warranty that ensures reliable operation of this product. The Shipping Policy and Return Policy pages outline complete details regarding shipping procedures and return processes.
If you want to save money in the long run on maintenance and repairs, you should choose OEM products because they're of the top level of durability. Are you on the quest of finding GM parts, our site is worth a visit. We stock an endless selection of high-quality GM components including things like ignition coils all the way through to fan shrouds and all at prices that can not be matched. You have nothing to worry about because all our OEM parts are covered with a manufacturer warranty, which guarantees superior quality and value.