GM 15151362
Window Switch, Passenger Side

The replacement process for the Door Lock and side window switch on the passenger side happens after complete removal of the front door trim panel. You must first remove the switch panel bezel securing screw from the frontdoor trim panel then separate the bezel from the door panel with a flat-bladed tool. Understand the retaining clips by using a wide plastic flat-bladed tool to start removing them from both edges of the door module before pulling out the door module from the switch panel bezel. Position the switch panel bezel with module back into the door trim panel after you set the module into switch panel bezel until it clicks. Fasten the switch panel bezel to the front door trim panel with screw while tightening the screw to 2 n.m (18 lb in). Program both tire pressure monitoring system and keyless entry system after you reinstall the front door trim panel. The door module programming requires additional steps if camper mirrors are installed on the vehicle.

Use a flat-bladed tool to pry upward on the leading edge of the switch.

Carefully bend the retaining tabs of the power door lock switch outward while pushing the switch out of the plate to remove it.

First, remove the switch mounting panel.

Press in the retainer springs with a small screwdriver.

Reinstall the power accessory switch plate.

Connect the power accessory electrical connectors to the switch, then install the switch to the door trim panel and snap it in place.

Position the power door lock and power window switch assembly into the switch panel, ensuring the front tabs slide in first, and rock the switch down to fully seat the door lock switch.

Lift the rear of the switch assembly and slide the switch out from the accessory switch panel.

Press in the retainer springs with a small screwdriver.

Press down on the switch, ensuring that the retainers lock into place.