Other Name: Actuator Kit, Door Lock; Trunk Lock Actuator Motor; Door Lock Actuator; Lock Actuator; Electric and Vacuum Door Locks; End Gate Electrical Actuator Kit.
Other Name: Actuator Kit, Door Lock; Door Lock Actuator; Lock Actuator; Actuator; Actuator Kit, Door Electric And Vacuum Locks; Actuator Kit, Door And End Gate Electrical
Other Name: Lock Assembly-Rear Side Door Front; Door Lock Actuator Motor; Door Latch Assembly; Door Lock Actuator; Door Lock; Lock; Latch, Door Lock Remote Control; Latch, Door Lock Remote
Other Name: Lock Assembly-Rear Side Door Front; Door Lock Actuator Motor; Door Latch Assembly; Door Lock Actuator; Door Lock; Lock; Latch, Door Lock Remote Control; Latch, Door Lock Remote
Other Name: Lock Assembly-Rear Side Door Rear; Door Latch Assembly; Door Lock; Latch; Lock, Rear Side Door; Lock, Door Lock
Position: Rear Passenger Side
Replaces: 10321723, 16675908
Item Weight: 1.00 Pounds
Item Dimensions: 6.4 x 3.3 x 3.2 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 10347139
Warranty: This genuine part is guaranteed by GM's
factory warranty.
More Info
Fits the following 2001 Chevrolet Venture Submodels:
Base, LS, LT, Plus, Value, Warner Bros. | 6 Cyl 3.4 L GAS
2001 Chevrolet Venture Door Lock Actuator
With a comprehensive array of OEM 2001 Chevrolet Venture Door Lock Actuator, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2001 Chevrolet Venture Door Lock Actuator are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.
2001 Chevrolet Venture Door Lock Actuator Parts Questions & Experts Answers
Q: How to Replace a Power Sliding Door Lock Actuator on 2001 Chevrolet Venture?
A: The replacement process of a power sliding door lock actuator starts with removing the sliding door inner trim panel together with the sliding door water deflector. The procedure starts by disconnecting the powersliding door latch release actuator electrical connector and after removing the securing screws the actuator can be taken off. Detach the actuator rod from its position on the actuator component. Begin the installation by mounting the actuator rod to the new actuator unit before installing it onto the powersliding door while adhering to the Fastener Notice in Service Precautions. Put screws on the actuator while tightening them to 10 N.m (89 lb in) then reinstall the sliding door water deflector and the inner trim panel.