OEM 2006 Cadillac CTS ABS Control Module

2006 Cadillac CTS Parts Questions & Experts Answers

• Q: How to replace the ABS Control Module on 2006 Cadillac CTS?

  A: You must switch the ignition to OFF before beginning ABS Control Module replacement work on the CTS to avoid equipment breakdown. Additionally keep the wiring harness disconnected from components whenever the ignition remains in the ON state. Dismantle ABS Control Module around its assembly while cleaning all contaminants from this area because contaminated ABS components might result from loose dirt within the clearance zone. After moving the retainer in the ABS Control Module electrical connector you should unlock the connector tab before disconnecting the ABS Control Module electrical connector from the ABS Control Module unit to allow placement on the side. The vehicle support procedure includes raising and securing a properly supported vehicle after discarding both upper ABS Control Module-to-BPMV screws. The first step requires removing the front air deflector while discarding the two screws which connect ABS Control Module to BPMV. Lower the vehicle for safe access to clean all surfaces between the ABS Control Module and BPMV units before ABS Control Module removal. The ABS Control Module will require replacement due to unrepairability when found faulty. The BPMV surface should be cleaned before attaching a new ABS Control Module to it with correct placement of the internal pump motor connector inside the ABS Control Module before the replacement process starts. Set up the new ABS Control Module screws in the upper positions of BPMV by applying fresh hardware after you remove the ABS Control Module from the BPMV. Raise the vehicle adequately and support it while installing the 2 lower NEW ABS Control Module to BPMV screws. Tighten all NEW ABS Control Module to BPMV screws in order (1-4) to 5 Nm (44 inch lbs.). Proposition the front air deflector and reduce the vehicle from height while establishing the ABS Control Module electrical connector to its corresponding receiving slot. Make sure the ignition remains switched OFF at this time. The ABS Control Module connector requires the tab to face the locked position followed by executing an auto bleed procedure with the scan tool after DTCs have been cleared. The installation process of a new ABS Control Module requires programming before conducting system checks on the vehicle and recalibrating the brake pedal position sensor.