OEM 2007 Chevrolet Corvette Steering Angle Sensor

2007 Chevrolet Corvette Steering Angle Sensor Parts Questions & Experts Answers

• Q: How to center the Steering Angle Sensor on 2007 Chevrolet Corvette?

  A: Begin sensor centering by identifying the sensor type through illustrated references before performing removal. Make a note that the sensor connector's front end will face right when checking its type. When repurposing the existing sensor there is no need for centering before extraction. Pull the sensor off the adapter and bearing assembly by disconnecting the sensor connector. Installation requires placing the FRONT of the sensor with a foam ring and pin hole for centering and a rotor flange cuff that stays flush. An alignment mark must be made on the rotor flange cuff before sensor removal for preventing unintended rotor position during reinstallation. A brand-new sensor arrives with a built-in pin; however, users should not remove this pin until they have correctly set the sensor in place. Leave the sensor's pin in place until the sensor completes its full insertion. After aligning the sensor to the steering shaft, install it within the adapter and bearing assembly before connecting the sensor. A pin hole occupies the sensor's front side while a raised rotor flange cuff exists alongside an alignment mark. You must align the marks present on the raised rotor flange cuff before sensor installment when reusing the part. Each sensor type requires the same alignment and installation process with special attention to note distinct installation characteristics including alignment marks and pin holes.