How to replace the lower control arm on 2007 GMC Envoy?

Vehicle elevation and tire-wheel removal is the first step before starting to replace the lower Control Arm. Using the steering linkage and tie rod puller (J 24319-B) remove the outer tie rod from the Steering Knuckle by first removing the outer tie rod retaining nut. The stabilizer shaft link lower retaining nut needs to be removed before disconnecting both the stabilizer shaft link and washer from the lower Control Arm. Use a steering linkage and tie rod puller (J 24319-B) to disconnect the shock module yoke from the lower Control Arm after removing its lower mounting nut. Use the Ball Joint remover (J 43631) to remove the lower Ball Joint from the Steering Knuckle after first discarding its retaining nut. When removing the lower Control Arm to lower Control Arm Bracket mounting nuts, keep track of bolt installation directions for later use but remove the mounting bolts while maintaining contact between the Axle Shaft and transmission (4WD only). First disconnect the lower Control Arm from its bracket while maintaining front bushing spacer position on the front Control Arm Bracket. Position the Control Arm downward and outward at a 90-degree angle to finish the removal. When installing the lower Control Arm start by positioning its Ball Joint stud onto the Steering Knuckle so that the spacer stays properly positioned before you pivot the Control Arm outward and upward to mate it with the lower Control Arm Bracket. When installing the lower Control Arm to its mounting bracket position the bolt through lower Control Arm Bracket while ensuring the arm stays parallel to the bracket during assembly and torque application. Screw in the mounting nuts until they reach torque specifications of 130 n.m (96 lb ft). Mount the shock module yoke to the lower Control Arm before applying the lower mounting nut with 110 n.m (81 lb ft) torque. Use a new lower Ball Joint retaining nut before tightening it to 110 n.m (81 lb ft). The stabilizer shaft link with washer needs to be installed onto the lower Control Arm. Then install the stabilizer shaft link retaining nut applying 155 n.m (114 lb ft) torque to it. Use a new retaining nut to install the outer tie rod to the Steering Knuckle then tighten it to 60 n.m (44 lb ft). Place the tire and wheel on the vehicle next follow a vehicle check of the front wheel alignment before raising it.

OEM 2007 GMC Envoy Control Arm

Suspension Arm

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

10 Control Arms found

View related parts
2007 GMC Envoy Lower Control Arm, Passenger Side
Part Number: 19133556
$225.77 MSRP: $384.35
You Save: $158.58 (42%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Arm, Steering Knuckle Control Arm and Ball Joint Assembly; Suspension Control Arm Assembly.
- Position: Passenger Side
- Replaces: 89060579
- Item Weight: 19.60 Pounds
- Item Dimensions: 4.6 x 18.4 x 16.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 19133556
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 GMC Envoy Submodels:
- Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
View related parts
2007 GMC Envoy Lower Control Arm, Driver Side
Part Number: 19133555
$225.77 MSRP: $384.35
You Save: $158.58 (42%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Arm, Steering Knuckle Control Arm and Ball Joint Assembly; Suspension Control Arm Assembly.
- Position: Driver Side
- Replaces: 89060578
- Item Weight: 18.50 Pounds
- Item Dimensions: 18.1 x 16.6 x 4.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 19133555
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 GMC Envoy Submodels:
- Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
View related parts
2007 GMC Envoy Upper Control Arm, Front Passenger Side
Part Number: 19330400
$106.61 MSRP: $181.51
You Save: $74.90 (42%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Arm Assembly, Front Upper Control; Suspension Control Arm; Control Arm; Arm, Steering Knuckle Upper & Lower Control
- Position: Front Upper Passenger Side
- Replaces: 15158963, 15080914, 15858683, 15077245, 15298273, 25786775
- Item Weight: 6.00 Pounds
- Item Dimensions: 2.8 x 12.8 x 11.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 19330400
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 GMC Envoy Submodels:
- Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
View related parts
2007 GMC Envoy Upper Control Arm, Front Driver Side
Part Number: 19330399
$104.56 MSRP: $179.55
You Save: $74.99 (42%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Arm Assembly, Front Upper Control; Suspension Control Arm; Control Arm; Arm, Steering Knuckle Upper & Lower Control
- Position: Front Upper Driver Side
- Replaces: 15077244, 15858682, 15158962, 15298272, 25786774, 15080913
- Item Weight: 5.90 Pounds
- Item Dimensions: 2.8 x 12.7 x 11.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 19330399
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 GMC Envoy Submodels:
- Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
View related parts
2007 GMC Envoy Upper Control Arm, Rear
Part Number: 15069837
Product Specifications
- Other Name: Arm, Rear Axle Upper Control; Control Arm; Arm, Rear Axle Control Arm
- Position: Rear Upper
- Item Weight: 4.40 Pounds
- Item Dimensions: 27.0 x 4.4 x 4.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: 15069837
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 GMC Envoy Submodels:
- Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
View related parts
2007 GMC Envoy Upper Control Arm, Rear
Part Number: 15098152
Product Specifications
- Other Name: Arm, Rear Axle Control Arm; Suspension Control Arm; Control Arm
- Position: Rear
- Item Weight: 4.30 Pounds
- Item Dimensions: 20.2 x 4.6 x 2.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: 15098152
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 GMC Envoy Submodels:
- Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
View related parts
2007 GMC Envoy Upper Control Arm, Rear
Part Number: 15098153
Product Specifications
- Other Name: Arm, Rear Axle Control Arm; Suspension Control Arm; Control Arm
- Position: Rear
- Item Weight: 4.50 Pounds
- Item Dimensions: 20.5 x 2.9 x 2.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: 15098153
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 GMC Envoy Submodels:
- Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
View related parts
2007 GMC Envoy Lower Control Arm, Rear
Part Number: 15098154
Product Specifications
- Other Name: Arm, Rear Axle Control Arm; Upper Control Arm
- Position: Rear
- Item Weight: 5.40 Pounds
- Item Dimensions: 21.1 x 3.0 x 2.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: 15098154
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 GMC Envoy Submodels:
- Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
View related parts
2007 GMC Envoy Upper Control Arm, Rear
Part Number: 15069838
Product Specifications
- Other Name: Arm, Rear Axle Upper Control; Control Arm; Arm, Rear Axle Control Arm
- Position: Rear Upper
- Item Weight: 4.80 Pounds
- Item Dimensions: 20.9 x 2.8 x 2.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: 15069838
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 GMC Envoy Submodels:
- Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
View related parts
2007 GMC Envoy Lower Control Arm, Rear
Part Number: 15069840
Product Specifications
- Other Name: Arm, Rear Axle Control Arm; Control Arm
- Position: Rear
- Item Weight: 5.00 Pounds
- Item Dimensions: 23.7 x 2.7 x 2.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- Require Quantity: 2
- SKU: 15069840
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 GMC Envoy Submodels:
- Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS

2007 GMC Envoy Control Arm

With a comprehensive array of OEM 2007 GMC Envoy Control Arm, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2007 GMC Envoy Control Arm are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2007 GMC Envoy Parts Questions & Experts Answers

Q: How to replace the lower control arm on 2007 GMC Envoy?
A: Vehicle elevation and tire-wheel removal is the first step before starting to replace the lower Control Arm. Using the steering linkage and tie rod puller (J 24319-B) remove the outer tie rod from the Steering Knuckle by first removing the outer tie rod retaining nut. The stabilizer shaft link lower retaining nut needs to be removed before disconnecting both the stabilizer shaft link and washer from the lower Control Arm. Use a steering linkage and tie rod puller (J 24319-B) to disconnect the shock module yoke from the lower Control Arm after removing its lower mounting nut. Use the Ball Joint remover (J 43631) to remove the lower Ball Joint from the Steering Knuckle after first discarding its retaining nut. When removing the lower Control Arm to lower Control Arm Bracket mounting nuts, keep track of bolt installation directions for later use but remove the mounting bolts while maintaining contact between the Axle Shaft and transmission (4WD only). First disconnect the lower Control Arm from its bracket while maintaining front bushing spacer position on the front Control Arm Bracket. Position the Control Arm downward and outward at a 90-degree angle to finish the removal. When installing the lower Control Arm start by positioning its Ball Joint stud onto the Steering Knuckle so that the spacer stays properly positioned before you pivot the Control Arm outward and upward to mate it with the lower Control Arm Bracket. When installing the lower Control Arm to its mounting bracket position the bolt through lower Control Arm Bracket while ensuring the arm stays parallel to the bracket during assembly and torque application. Screw in the mounting nuts until they reach torque specifications of 130 n.m (96 lb ft). Mount the shock module yoke to the lower Control Arm before applying the lower mounting nut with 110 n.m (81 lb ft) torque. Use a new lower Ball Joint retaining nut before tightening it to 110 n.m (81 lb ft). The stabilizer shaft link with washer needs to be installed onto the lower Control Arm. Then install the stabilizer shaft link retaining nut applying 155 n.m (114 lb ft) torque to it. Use a new retaining nut to install the outer tie rod to the Steering Knuckle then tighten it to 60 n.m (44 lb ft). Place the tire and wheel on the vehicle next follow a vehicle check of the front wheel alignment before raising it.

Related 2007 GMC Envoy Parts

Alternate Year Models

2006 GMC Envoy Control Arm 2008 GMC Envoy Control Arm