OEM 2008 Chevrolet HHR Brake Caliper Bracket

2008 Chevrolet HHR Parts Questions & Experts Answers

• Q: How to replace the rear brake caliper bracket on 2008 Chevrolet HHR?

  A: First support the brake caliper with heavy-duty mechanic wire during replacement because the hydraulic line stays connected. Dispose the caliper from its bracket keeping the hydraulic hose connected followed by pad and retainer removal from the bracket. If you want to keep the bracket clean both parts of the pad hardware from dirt and rust. Replace any disc Brake Pad retainers that show bent mounting tabs, severe rust, movement at the mounting bracket, or at the Brake Pad contact area. Take out the bolts securing the Brake Caliper Bracket then disconnect it from the rear axle. Evaluate the caliper bracket for bending damage and examine it for cracks before deciding on replacement. Examine both brake caliper guide pins (1, 4) for smooth movement while inspecting their boots for acceptable condition and no signs of restrictions, loosening, seizing, or tearing; replace defective parts immediately. The brake caliper mounting bracket connects to the rear axle as its self-retaining fastener needs no thread locking compound. Fasten the Brake Caliper Bracket bolts securely at 115 n.m (85 lb ft). Use silicone brake lubricant only on mating surfaces of hardware parts and thoroughly clean retainers before placing them on the two kneecap parts. You should always position the Brake Pad wear sensor inside the rotor when mounting it with its leading edge on the brake rotor surface next to the wheel rotation direction. After attaching the brake pads to the caliper bracket put back the support and lower the caliper assembly above the pads until you can insert it onto the mounting bracket.