Q: How to replace the Air Bag Sensor for the side impact on Buick LaCrosse?
A: To be able to replace the inflatable restraint side impact sensor the first step involves disabling the SIR system. Make sure the sensor is not hit or shaken and it is properly secured before connecting to power to prevent deployment or harm. Put up the window for access then get rid of the door trim panel and enough of the water deflector to gain access to the sensor. Unscrew the bolts holding the sensor then remove the sensor from the door and sever the connector position assurance (CPA) from the side impact sensor connector. Remove the sensor, clean up the mounting surface, mount the new sensor near the door, and connect the side impact sensor connector. Mount the CPA onto the connector and bolt the sensor to the door applying a torque of 10 N.m (89 lb in). After that, re-install the water deflector and activate the SIR system.
Q: Should the SIR/side air bag sensor be replaced in the area of accident damage on Buick LeSabre?
A: The sir/side Air Bag Sensor requires replacement when installed in regions affected by car collision damage which includes all vehicle areas that experience crushing or bending or sustained visible damage during the accident such as moderate tree impacts. Replacement of an sir sensor located forward of the Radiator becomes necessary even when air bags have not deployed and the sensor shows no signs of damage. The sir/side air bag sensing system requires a sensor replacement because slight bending of mounting brackets and wire insulation damage cannot be inspected thus affecting sensor performance thus demanding immediate replacement. The replacement of faulty sensors becomes necessary when diagnostic trouble codes appear within the system.
Q: How to service the Air Bag Sensor for the side impact on Buick Regal?
A: Service procedures for the inflatable restraint side impact sensor (SIS) require disabling the SIR system first. Before powering the SIS keep it secured to the mounting points through proper fasteners to protect yourself from accidental deployment or harm. Start by taking out the lower trim from the center pillar and unstow the 2 fasteners that hold the inflatable restraint side impact sensor. Afterward, extract the sensor from the center pillar. Processing begins with disconnecting the connector position assurance (CPA) from the side impact sensor connector followed by disconnection of the connector. Before installation wipe off the mounting area from contaminants then add the side impact sensor connector and place the CPA into position. Place the side impact sensor onto the center pillar while keeping its arrow-side forward. Fasten the sensor with the provided hardware until it achieves 10 N.m (89 lb in) torque through hand tightening. Reinstall the center pillar lower trim before enabling SIR system operation.