Q: How to replace the antenna cable on Buick LaCrosse?
A: The Antenna Cable replacement process starts with removing the rear seat cushion followed by the rear seat back and left rear quarter lower panel and final step involves removing the left rear upper quarter trim panel. Start the replacement by disconnecting the Antenna Cable from the radio antenna module while lowering the rear section of the headliner. Begin by taking out two pieces of trim that include the lower center pillar and left lower pillar garnish. The carpet should be adjusted to provide clearance for accessing either the Antenna Cable or body harness. The installation process requires the Antenna Cable to detach from the antenna extension cable. Secondly, use scissors to cut off both Antenna Cable ends from the wiring harness at the lower pillar garnish molding and rear header area. The Antenna Cable installation requires electrical tape to secure it onto the wiring harness top at least every 150 mm (6 in). Next attach the Antenna Cable to the antenna extension cable and return the carpet and lower center pillar trim panel alongside the left lower pillar garnish molding. The Antenna Cable needs installation to the radio antenna module before reinstalling the same sequence of components including headliner and left rear upper quarter trim panel followed by left rear quarter lower trim panel before returning the rear seat back and rear seat cushion.
Q: How to Replace an Antenna Cable for Extension Cable on Buick LeSabre?
A: The procedure to replace the antenna cable starts with radio removal followed by disconnecting the antenna cable. Remove both the right side windshield garnish molding along with the upper instrument panel trim pad. Begin by removing cable clips taped to the instrument panel support while disconnecting the coaxial cable connector. Remove the antenna cable from the vehicle as a next step. Connect the coaxial cable connector and install cable clips to the instrument panel support during the installation process. Feed the new antenna cable through the radio cavity opening before making its connection to the radio. Reinstall the radio followed by upper instrument panel trim pad then right side windshield garnish molding.
Q: How to Replace an Antenna Cable on Buick Regal?
A: The Antenna Cable replacement process starts by taking out the right upper quarter trim panel followed by disconnecting the body harness antenna extension cable from the Antenna Cable. Then continue with the sequence of removing the rear seat cushion along with the right instrument panel (I/P) insulator and three carpet retainers for right front, right rear and the lower trim panel from the right center pillar. To reach the wiring harness pull up the right carpet side before disconnecting the i/p antenna extension cable from the body harness Antenna Cable at the front door hinge pillar. Use scissors to cut off visible Antenna Cable parts and place the cuts at points where you observed how the Antenna Cable routed itself. Install the Antenna Cable to the harness at intervals of 150 mm (6 in) and secure the extension cables with electrical tape placed along the wiring harness exterior. Connect the i/p antenna extension cable to the body harness Antenna Cable located at the front door hinge pillar before reinstalling right carpet along with lower trim panel to right center pillar followed by right rear carpet retainer then right front carpet retainer then right i/p insulator and finally rear seat cushion. Move the antenna extension cable to body harness Antenna Cable then replace the right upper quarter trim panel.