Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1984-1996 Buick Century | Custom, Estate Wagon, Limited, Special, T-Type | 4 Cyl 2.2 L GAS, 4 Cyl 2.5 L GAS, 6 Cyl 2.8 L GAS, 6 Cyl 3.0 L GAS, 6 Cyl 3.1 L GAS, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 4.3 L DIESEL
Buick Century Wiper Arm
Our website offers an extensive catalog of genuine Buick Century Wiper Arm at unbeatable prices. Every OEM Buick Century Wiper Arm comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Buick Century Wiper Arm Parts Questions & Experts Answers
A: Before replacing the Wiper Arm switch to accy while setting the Wiper Switch to pulse then turn off the ignition. Press the ignition button when your wipers pause at the bottom point of their motion. First disconnect the washer hose from the washer nozzle and then remove the cover from the nut. After that take off the Wiper Arm and wiper transmission drive shaft nut. To continue with Wiper Arm removal use the Wiper Arm puller tool reference number j 39822. Press and rock the Wiper Arm off the wiper transmission drive shaft before you uninstall the Wiper Blade. To install the wiper system start by adding the Wiper Blade to the Wiper Arm and applying the Wiper Arm to the wiper transmission drive shaft. Turn on the accy mode and set the Wiper Switch at pulse to verify correct windshield wiper system function. Stop the engine once the wiper drive system rests at the bottom of its motion. At installation put the measuring device parallel to the Wiper Blade and insert the same-size tool into the Wiper Arm. Mount the Wiper Arm onto the wiper transmission drive shaft through proper locations. Keep the Wiper Arm tip 12 to 147 mm or 4.92 to 5.78 inches from the left air inlet grill panel and 97 to 107 mm or 3.82 to 4.21 inches from the right air inlet screen. Screw the drive shaft nut onto the wiper transmission and Wiper Arm then tighten it to 30 newton-meter (22 pound foot). Apply windshield washer solvent on the hose end and insert the pin back into its place before connecting the washer hose to the nozzle. Use the wipers before checking if they function as intended.