In order to replace the coolant recovery reservoir, you will first have to move the Coolant Reservoir hose clamp to a place not obstructing the radiator overflow fitting and remove the Coolant Reservoir hose from the fitting. Remove the Coolant Reservoir hose support retainer from the electrical harness, and then take out the reservoir nuts from the shock tower studs along with the removal of the coolant recovery reservoir from the lower retainer and shock tower studs. Drain the recovery reservoir coolants into a clean container. For installation, you should mount the coolant recovery reservoir back onto the lower retainer and shock tower studs and install the nuts on the studs and tighten them to 3.3 nm (29 inch lbs.). Lubricate the reservoir hose with clean water and we will route it to the radiator overflow neck fitting, with the end of hose flush on the radiator filler neck and the clamp squarely between the neck and flared end of the fitting before we instal the the Coolant Reservoir hose to radiator overflow fitting. Connect the support retainer for the Coolant Reservoir hose to the electrical harness, align the Coolant Reservoir hose clamp to the radiator overflow fitting, and fill the position of the coolant recovery reservoir to the correct level.