Q: How to replace the trailing arm on Buick LaCrosse?
A: To replace the trailing arm, first, lift up and hold the vehicle. Remove nut and bolt from the trailing arm and the knuckle , as well as nut and bolt from the trailing arm and trailing arm bracket. After this removal, take the trailing arm from the vehicle. During the installation, flag the trailing arm on the trailing arm bracket, make sure that one adheres to the fastener notice and the precautions mentioned in the fastener notice. Next, fit the bolt and nut to attach the trailing arm to the trailing arm bracket, tightening until 110 N.m (81 lb ft). Then attach one end of the trailing arm to the knuckle and add the bolt and nut , securing the nut to 240 N.m (177 lb ft). Finally, lower the vehicle.
Q: How to replace the trailing arm (6) on Buick Century?
A: Next, to replace the trailing arm, first, lift and support the vehicle. Lift the bolt and nut used in the connection of the trailing arm to the knuckle, followed by removal of the nut and bolt from the trailing arm to the trailing arm bracket, and then remove the trailing arm from vehicle. For installation attach the trailing arm to the trailing arm bracket making sure to observe the Fastener Notice in Service Precautions. Ensure the connection with the bolt and nut, by tightening the bolt at 105 Nm (77 ft. lbs). Next install the trailing arm to the knuckle and attach bolt and nut while you tighten the nut 70 Nm + 65 degrees (52 ft. lbs. + 65 degrees). Finally, lower the vehicle.
Q: How to service and repair the trailing arm on Buick Regal?
A: First, raise and support the vehicle to service and repair the Trailing Arm. Attributes of the installation process shall be undertake using the torque angle meter (J 36660-A), as it will be useful in determining the values of torque depending on the angle. Remove the abs electrical connector from the Wheel Speed Sensor , before also removing the Trailing Arm from the knuckle and from the Trailing Arm bracket before removing it. For the installation, connect the Trailing Arm to the Trailing Arm bracket by installing the bracket bolt and nut and tighten the bracket nut to 105 nm (77 ft. Lbs.). Subsequently, attach the Trailing Arm to the knuckle and tighten the Trailing Arm to knuckle nut to 260 nm (192 ft. Lbs.). Finally, reconnect the abs electric connector from the Wheel Speed Sensor and drop your vehicle.