Other Name: Sensor Assembly, Vehicle Speed; Vehicle Speed Sensor; Sensor, Computer Control Sensors; Sensor, Speedometer Drive; Sensor, Speedometer
Fits the following Buick Models:
Century | 1991-1993, 1988-1989 | Custom, Estate Wagon, Limited, Special | 4 Cyl 2.2 L GAS, 4 Cyl 2.5 L GAS, 6 Cyl 2.8 L GAS, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS
| Page 1 of 2 |Next >
1-20 of 25 Results
Buick Vehicle Speed Sensor Parts Questions & Experts Answers
Q: How to replace the Vehicle Speed Sensor on the 4T80-E Automatic Transaxle on Buick Lucerne?
A: Start the process by raising the vehicle for 4t80-e automatic transaxle Vehicle Speed Sensor replacement. Take out the two bolts (1, 3) keeping the front transaxle brace attached to the transaxle and right engine side. Push down the Vehicle Speed Sensor knob to disconnect its power and take out the bolt (131) and sensor (130) by turning the sensor counterclockwise and pulling straight out. After inserting Vehicle Speed Sensor part 130 you should install the bolt 131 while also lining up a new o-ring seal. Then hand-tighten the bolt until torque reaches 10 n.m. Reinstall bolts 1 and 3 to fasten the front transaxle brace to its positions on the transaxle and right Cylinder Head. Reattach the electric Vehicle Speed Sensor connector afterward. Finally, lower the vehicle.
Q: How to Replace a Vehicle Speed Sensor on Buick LeSabre?
A: The first step for vss replacement consists of raising and supporting the vehicle while you perform the replacement work. Disconnect the electrical connector at the Vehicle Speed Sensor before removing the sensor's retaining bolt. Check the condition of the o-ring and get a new one if needed. Anchor the Vehicle Speed Sensor by installing its retaining bolt before torquing the bolt to 10 nm (89 inch lbs.). Reattach the electrical connector to the sensor followed by removing safety stands from underneath the vehicle while lowering it down. Fully connect the negative Battery Cable while maintaining a 15 nm (11 ft. Lbs.) torque on the terminal bolt.
Q: How to Replace a Vehicle Speed Sensor (VSS) on Buick Rendezvous?
A: First raise and support the vehicle before starting the Vehicle Speed Sensor (VSS) replacement procedure. Start by disconnecting the vehicle speed sensor's electrical connector before removing its retaining bolt and sensor (110). Rinse the O-ring to inspect it for wear. If damaged, get a new one installed. Screw the vehicle speed sensor into place while tightening the bolt to 12 Nm (106 inch lbs.). Photons must attach the sensor electrical connector before lowering the vehicle.