The replacement process of front drive axle inner shaft seal and inner shaft bearing requires these tools: j 8092 universal driver handle (J 8092), j 2619-01 slide hammer (J 2619-01), j 29369-1 bushing and bearing remover (J 29369-1), j 29369-2 bushing and bearing remover (2-3 inch) (J 29369-2), j 36609 axle tube bearing installer (J 36609), and j 45225 axle seal installer (J 45225). Begin the procedure by raising the vehicle and storing the differential carrier assembly fluids. Start the procedure by eliminating right side seal or bearing while performing inner Axle Shaft housing removal from the differential carrier case then removing Clutch Fork assembly parts. Lock down the inner Axle Shaft housing using a vise which should grip only the mounting flange of it. The j 29369-1 or j 29369-2 should be positioned behind the inner Axle Shaft seal or bearing and the j 2619-01 should be attached to either tool to successfully remove both elements. The procedure for left side seal replacement includes marking the inner Axle Shaft and wheel drive shaft alignment before shock module removal (for 8.25 inch axle service), disconnecting the wheel drive shaft and using a hammer and brass drift to remove the inner Axle Shaft and seal. To change both left side seal and bearing components physically remove the differential carrier assembly and place it within a vise before repeating the installation procedure. Installation of the right side bearing requires using j 36609 then j 8092 followed by application of j 45225 and j 8092 to install the new Axle Shaft seal. Tighten the inner Axle Shaft through careful impacts before reinstalling Clutch Fork components and the housing assembly with the inner Axle Shaft. Reinstall the bearer and seal combination on the left side of the differential carrier only when both original components were previously removed. Apply the proper fluid into the differential carrier assembly before lowering the vehicle.