Other Name: Stud Kit, Front Lower Control Arm Ball; Ball Joint; Stud Kit, Steering Knuckle Lower Control Arm Pivot; Stud Kit, Front Wheel Lower Control Arm
Other Name: Ball Joint, Lower Control Arm; Suspension Ball Joint; Ball Joint, Steering Knuckle Lower Control Arm Pivot; Ball Joint, Front Wheel Lower Control Arm
Position: Lower
Fits the following Cadillac Models:
Eldorado | 1984-1985 | Base, Biarritz | 8 Cyl 4.1 L GAS, 8 Cyl 5.7 L DIESEL
Other Name: Stud Kit, Front Lower Control Arm Ball; Suspension Ball Joint; Ball Joint; Stud Kit, Steering Knuckle Lower Control Arm Pivot; Front Wheel Lower Control Arm; Rear Axle Control Arm.
Position: Front Lower
Replaces: 09766421, 9766421
Fits the following Cadillac Models:
DeVille | 1984 | Base, Cabriolet, d'Elegance | 8 Cyl 4.1 L GAS, 8 Cyl 5.7 L DIESEL
Fleetwood | 1984 | Brougham, Brougham d'Elegance | 8 Cyl 4.1 L GAS, 8 Cyl 5.7 L DIESEL
| Page 1 of 2 |Next >
1-20 of 21 Results
Cadillac Ball Joint Parts Questions & Experts Answers
Q: How to replace the lower ball joint on a with torsion bar suspension on Cadillac Escalade?
A: You must raise and hold the vehicle before disassembling the tire wheel assembly and lower Control Arm so you can switch out the lower Ball Joint on a vehicle with its torsion bar suspension. Position the Control Arm in a vise clamp and use a chisel to remove the clips from the joint body only when they exist. Set the Ball Joint into the press tool to detach it from the lower Control Arm. Insert the new Ball Joint through the outer flange into place and put the lower Control Arm back into the vice for installation. You can use a punch to attach crimps onto the Ball Joint after matching them with the original replacement parts. Insert the lower Control Arm first and put back the tire and wheel unit afterward. With stands removed place the vehicle back to ground level and test the wheel alignment.
Q: How to replace the lower ball joint on a 2500 Series on Cadillac Escalade EXT?
A: Start the lower Ball Joint replacement process by lifting the vehicle then taking off its tire and wheel as well as its lower Control Arm. Place the lower Control Arm in a bench vise and remove securing crimps from the joint body using a sharp tool. Set up a press to take out the Ball Joint from its position on the lower Control Arm. Fasten the new Ball Joint by pressing it into the outer flange before putting the lower Control Arm back in its vice position. Fix crimped balls onto the new Ball Joint by pressing if required while following the position of the old joint. Insert the lower Control Arm afterward add the tire and wheel parts. Take the vehicle down and check wheel alignment when you take away the safety stands.
Q: How to replace the lower ball joint in a coil spring suspension on Cadillac Escalade ESV?
A: You need to lift and stabilize the vehicle before taking off the wheel and tire to replace the lower Ball Joint in a coil spring suspension. Fix the lower Control Arm in a bench vice setup before removing it. Strike the rivet heads with a center punch and drill out the rivets to get the lower Ball Joint out. Connect and install the new Ball Joint to the lower Control Arm while applying bolts with torque according to the fastener notice instructions. Use a wrench to place and tighten the bolt nuts to 70 nm (52 ft. Lbs). Set the lower Control Arm back into the vehicle after taking it from the bench vice. Then add the tire and wheel assembly. Take away the safety stands then lower the vehicle and check wheel alignment.