ChevyParts
My Garage
My Account
Cart
OEM Cadillac XLR Differential Cover
- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
8 Differential Covers found
Cadillac XLR Carrier Cover
Part Number: 19132786$130.88 MSRP: $205.93You Save: $75.05 (37%)Ships in 1-3 Business Days
Cadillac XLR Carrier Cover
Part Number: 19132905$53.79 MSRP: $342.47You Save: $288.68 (85%)Ships in 1-2 Business DaysCadillac XLR Carrier Cover
Part Number: 19132787$32.81 MSRP: $208.88You Save: $176.07 (85%)Ships in 1-2 Business Days
Cadillac XLR Differential Cover
Our website offers an extensive catalog of genuine Cadillac XLR Differential Cover at unbeatable prices. Every OEM Cadillac XLR Differential Cover comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Cadillac XLR Differential Cover Parts Questions & Experts Answers
- Q: How to replace the LH Differential Cover and seal on Cadillac XLR?A: To replace the Differential carrier cover and seal on the left-hand side, raise the vehicle and adequately support it. Dismount the lh rear tire and wheel assembly 02100-020-lh wheel drive shaft and the lh Muffler assembly 02020-020-lh tire wheel wells muffle duct. Drain the fluid from the Differential, then raise the Differential, then remove the left Differential mount. Clean around it of any dirt or debris and then take out the two bolts that hold the Differential cover in place and push out the dowel pin. Carefully remove the Differential cover and make sure the magnet at the bottom of the Differential case is not thrown away. Remove the o-ring seal as well as the axle seal from the Differential side cover. For installation, clean the o-ring sealing surface on the Differential cover and the Differential housing, and fix a new o-ring seal on the Differential cover. Mount the Differential cover onto the Differential, put the dowel pin and the two bolts for Differential cover retaining at work, tightening them 28 n.m (20 lb ft). Tight up the bolt containing the left Differential mount to 50 n.m (37 lb ft). Since the axle seal was successfully installed using a j 46405 output shaft seal installer, install the axle seal into the Differential cover. Add the appropriate fluids into the Differential up to the right level, then reinstall the lh Muffler assembly, the lh wheel drive shaft, and the lh rear tire and wheel assembly before lowering the vehicle.
