Q: How to replace the air filter element on Chevrolet Impala?
A: The main step to replace the Air Filter starts with removing the air cleaner outlet duct. Before proceeding disconnect the secondary air injection (AIR) pump hose quick connect fitting that attaches to the air cleaner housing cover. The air cleaner housing cover requires removal after unclamping its spring units above it for you to reach the Air Filter. The repair of the Air Filter requires installation of a new filter alongside reinstallation of the air cleaner housing cover. Replace your air cleaner housing cover first before attaching the quick connect fitting of the air pump hose to the air cleaner housing cover. Wrap the spring clamps on top of the air cleaner housing for support. You need to reposition the outlet duct of the air cleaner.
Q: How to service the Air Filter element on Chevrolet Malibu?
A: Firstly, turn off the ignition to service the Air Filter. Take the Air Filter retaining screws off and remove the cover and remove the Air Filter and inspect it for the need of a replacement. Remove the m.a.f (Mass Air Flow Sensor) sensor electrical connection, at (Automatic Transmission) sensor electrical connector, and the breather tube from the air intake duct. Take out the air intake duct by loosening the two air intake duct clamps. For installation, insert the Air Filter on the air cleaner assembly and cover it using the Air Filter cover. Bone the filter retainer screws, tighten them to 5-7 n.m (35-45 lb in). Reinstall the air intake duct and tighten the two air intake to duct clamps. Connect the breather tube to the air intake duct, connect the at sensor electrical and the mass air flow (MAF) sensor's electrical connection next.
Q: How to replace the air filter on Chevrolet SSR?
A: You should start by opening the hood to loosen the bolts between the front and rear air cleaner housings before removing them both. First remove the old Air Filter then install a new Air Filter. Follow the fastener notice in service precautions when you install the rear air cleaner housing onto the front air cleaner housing. Insert the front to rear air cleaner housing bolts before tightening them to 3 n.m (27 lb in), then close the hood.