Other Name: Control, Heater And Air Conditioner Control; Climate Control Module; Blower Control Switch; Dash Control Unit; Control, Heater And A/C Control
Replaced by: 23344087
Fits the following Chevrolet Models:
Corvette | 2014-2019 | Grand Sport, Stingray, Z06, ZR1 | 8 Cyl 6.2 L GAS
Q: How to replace the auxiliary A/C blower control switches on Chevrolet Astro?
A: Set the parking brake and turn the ignition key to on position. Also move the gear selector to 1st gear before starting the switch replacement. Press the tilt steering control all the way down when it has a lower position setting. Pull the edges of the instrument panel cluster trim plate while grasping it. Then remove the plate when its retainers release from the instrument panel. Press both sides of the auxiliary a/c blower motor switch out from its position in the instrument panel cluster trim plate. Fit the tabs on the sides of the new auxiliary a/c blower motor switch into the instrument panel cluster retaining plate. Push the instrument panel cluster trim plate into the panel opening to seat its retainers. Turn the gear selector to park and switch the ignition to off then release the brake.
Q: How to replace the blower control switches on Chevrolet Camaro?
A: Before replacing the HVAC control blower switch you must disconnect the heating ventilation and air conditioning (HVAC) control. Begin by taking out your HVAC control and then removing its blower knob before unscrewing the blower switch. Unplug the control unit to remove the HVAC control blower switch. Reposition the HVAC control blower switch into its designated place first. Install the HVAC control blower switch screw per Service Precautions and fasten it to 2 N.m torque setting. Reinsert the HVAC control blower knob into position and put back all control parts.
Q: How to replace the blower control switches on Chevrolet Tracker?
A: You can replace the blower switch by taking the heater control assembly from the ip panel to get better access to the switch within the vehicle. Unscrew the locking tabs from both parts of the heater control unit before taking out the blower switch . Reinsert the blower switch into the heater control unit before putting back the heater control assembly.