Other Name: Emblem, Radiator Grille And Front End Ornamentation
Position: Front
Replaces: 25961384, 22774272, 25872995
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2008-2012 Chevrolet Malibu | Hybrid, LS, LT, LTZ | 4 Cyl 2.4 L FLEX, 4 Cyl 2.4 L FULL HYBRID EV-GAS (FHEV), 4 Cyl 2.4 L GAS, 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 6 Cyl 3.6 L GAS
Other Name: Emblem, Rear End Panel And Tailgate; Emblem,Rear End Panel And Tailgate
Position: Rear
Replaces: 22619105
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2000-2003 Chevrolet Malibu | Base, LS | 6 Cyl 3.1 L GAS
| Page 1 of 2 |Next >
1-20 of 29 Results
Chevrolet Malibu Emblem
Our website offers an extensive catalog of genuine Chevrolet Malibu Emblem at unbeatable prices. Every OEM Chevrolet Malibu Emblem comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Malibu Emblem Parts Questions & Experts Answers
Q: How to replace the emblem/nameplate on the rear compartment lid on Chevrolet Malibu?
A: Before you put on the back lid nameplate cover you need to shield the bottom surface and pencil installation points. Heat the Emblem/nameplate using the heat gun (J 25070) in circular movement for 30 seconds at a 152 mm (6 inch) distance from the surface. You can safely take out the Emblem/nameplate with a plastic tool when heated. Body panels need the 3m(TM) scotch brite molding adhesive remover disk (parts number 07501) for removal while plastic panels require a lint-free cloth with vmp naptha or isopropyl alcohol and water mixture in equal parts for cleaning. Wipe the installation region with the same cloth and wiping liquid before complete drying. If the Emblem/nameplate location is unmarked, apply tape and use specified dimensions for proper placement: for the chevy bow tie Emblem, center it on the rear compartment lid with dimension (A) at 192 mm (7.560 in) from the bottom; for the v6 Emblem, place it with dimension (a) at 20 mm (0.780 in) from the left edge and dimension (b) at 27 mm (1.062 in) from the tail lamp; for the malibu ls Emblem, position it with dimension (a) at 38 mm (1.500 in) from the left edge, dimension (b) at 17 mm (0.670 in) between the malibu and ls emblems, and dimension (c) at 29 mm (1.141 in) from the tail lamp. Use the heat gun (J 25070) to warm the surface up to 80-105°f while making sure the Emblem/nameplate reaches 85-90°f temperatures. Carefully place the Emblem/nameplate without touching its adhesive and apply it to the correct spot on the surface using equal force until the adhesive bonds then peel off protective tape.