Other Name: Bearing, Front Wheel Inner; Axle Bearing; Wheel Bearings; Front Inner Bearing; Bearing Assembly, Transmission Main Shaft; Gear Bearings; Front Outer Bearing.
Position: Front
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1995-2000 Chevrolet Tahoe | Base, Limited, LS, LT, Z71 | 8 Cyl 5.7 L GAS, 8 Cyl 6.5 L DIESEL
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2007-2014 Chevrolet Tahoe | Hybrid, LS, LT, LTZ, PPV, SSV | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV), 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2021-2023 Chevrolet Tahoe | Commercial, High Country, LS, LT, PPV, Premier, RST, SSV, Z71 | 6 Cyl 3.0 L DIESEL, 8 Cyl 5.3 L GAS, 8 Cyl 6.2 L GAS
| Page 1 of 2 |Next >
1-20 of 22 Results
Chevrolet Tahoe Wheel Bearing
Our website offers an extensive catalog of genuine Chevrolet Tahoe Wheel Bearing at unbeatable prices. Every OEM Chevrolet Tahoe Wheel Bearing comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Tahoe Wheel Bearing Parts Questions & Experts Answers
Q: How to replace the rear axle wheel bearing and wheel seal on Chevrolet Tahoe?
A: The process starts with vehicle elevation followed by wheel support then tire removal. The rear axle housing cover must also be removed before extracting the Axle Shaft. First stabilize the vehicle by raising it before you remove the rear axle housing cover and detach the Axle Shaft. To pull off the rear Axle Shaft seal of vehicles with vses functionality practitioners need to utilize both the j 44685 - rear axle seal and bearing remover together with the j 2619-01 - slide hammer. You can remove the rear Axle Shaft seal and bearing and wheel speed sensor reluctor ring with the j 45857 - vses wheel bearing remover alongside the j 2619-01 - slide hammer when present on the vehicle. Before installing the rear wheel speed sensor reluctor ring users must verify that the Axle Shaft bearing sits properly within its housing inside the rear axle housing. Use the j 23690 - axle bearing installer together with the j 8092 - universal driver handle to put the Axle Shaft bearing in place before you install the Axle Shaft seal with the j 21128 - axle pinion oil seal installer while driving it into position until it is flush. After installing the rear Axle Shaft reinstall the housing cover before replacing the tire and wheel assembly. Top off your vehicle's rear axle with recommended differential oil before removing the tire lift support.