What tools are required to service and repair the CV Joint for front wheel drive shaft outer joint and seal replacement on Chevrolet Venture?

Question

Accepted Answer

For this service and repair of the constant velocity joint, namely for the front wheel drive shaft outer joint and seal replacement, the following tools are necessary: drive axle swage ring clamp (J 41048), snap ring pliers (J 8059 ), and drive axle seal clamp pliers (J 35910). To start with, use a side cutter to remove the massive seal retaining clamp from the CV Joint and dispose of it. Use a hand grinder to cut and sever the swage ring for it to be removed. Remove the halfshaft outboard seal from the CV Joint outside race and slide it away from the junction towards the halfshaft bar. Apply grease removal from CV Joint inner race and depression snap ring pliers on ears race retaining ring. Take out the CV Joint assembly and remove the halfshaft bar from the CV Joint assembly, then discard the used outboard seal. A brass drift is carefully used to tap and tilt the CV Joint cage until the chrome alloy balls have been taken out one by one a total of six times. Clean inner and outer race assemblies, CV Joint cage, and chrome alloy balls to remove all the old grease and contaminants using the cleaning solvent and let dry all components and inspect for severe wear, cracks, or damages and replace the damaged parts. Use a wire brush to clean the halfshaft bar and remove rust in the seal mounting area. Mount into assembly the new swage ring onto the seal outboard neck without swaging; then place the outboard seal around the halfshaftbar; place it in the seal groove. Swage the ring on using the drive axle swage ring clamp by aligning the bolt, then tighten the bolts alternately and until they are snug, then inspect the deformities and re-swage if required. Use a thin layer of grease onto the ball grooves of the inner and outer races, pack the inner race into the cage and align it with the outer race. Press in the chrome balls, filling the CV Joint with grease, and make sure the outboard seal is correctly shaped. At last, slide large diameter of the outboard seal onto the outer race of CV Joint with large seal retaining clamp in place and crimp the clamp by using the drive axle seal clamp pliers to the specified torque and examine the gap dimension on the clamp ear.

OEM Chevrolet Venture CV Joint

8 CV Joints found

Chevrolet Venture CV Joints, Front

Chevrolet Venture Outer CV Joint

Chevrolet Venture Housing Assembly, Front Driver Side

Chevrolet Venture CV Joints, Front

Chevrolet Venture C.V. Joint, Outer

Chevrolet Venture Axle Assembly

Chevrolet Venture CV Joints, Front

Chevrolet Venture CV Joints, Front

Chevrolet Venture CV Joint

Chevrolet Venture CV Joint Parts Questions & Experts Answers

Related Chevrolet Venture Parts

Browse Chevrolet Venture CV Joint by Years