Other Name: Module Assembly-Electronic Brake Control (W/Brake Pressure Mode; ABS Control Module; Modulator Valve; ABS Control Unit; Pressure Modulator Valve; Module, Electronic Brake Control
Replaced by: 85719285
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2018-2024 GMC Savana 3500 | Base, LS, LT | 4 Cyl 2.8 L DIESEL, 6 Cyl 4.3 L FLEX, 6 Cyl 4.3 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L GAS
Other Name: Module Kit, Electronic Brake Control (Ebcm); ABS Control Module; Module Kit, Electronic Brake Control
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1996-2002 GMC Savana 3500 | Base, SLE, SLT | 6 Cyl 4.3 L GAS, 8 Cyl 5.7 L BI-FUEL, 8 Cyl 5.7 L GAS, 8 Cyl 6.5 L DIESEL, 8 Cyl 7.4 L GAS, 8 Cyl 8.1 L GAS
| Page 1 of 2 |Next >
1-20 of 26 Results
GMC Savana 3500 ABS Control Module
Our website offers an extensive catalog of genuine GMC Savana 3500 ABS Control Module at unbeatable prices. Every OEM GMC Savana 3500 ABS Control Module comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
GMC Savana 3500 ABS Control Module Parts Questions & Experts Answers
Q: How to replace the ABS Control Module on GMC Savana 3500?
A: A proper support system for the vehicle must be installed when replacing the ABS Control Module. Remove the three EHCU shield bolts from the shield followed by disconnecting the four electrical connectors attached to the ABS Control Module. Remove the EHCU bracket from the frame using the three bolts before extracting the EHCU with caution and without bending any attached brake pipes. Apply gentle force when removing the ABS Control Module from its mounting on the BPMV by taking out its four T-25 Torx bolts. The BPMV requires cleaning with a dry and clean cloth. To install the new ABS Control Module properly onto the BPMV, check for corrosion on mounting bolts and replace them while avoiding the application of RTV or any sealant on ABS Control Module gasket or mating surfaces. Similar to bolt installation on the ABS Control Module, use an X-pattern when tightening the bolts to 5 Nm (39 inch lbs.). Secure the new ABS Control Module using its four connections before installing and securely tightening the EHCU cover through three bolts to 12 Nm (8 ft. lbs.). The vehicle must be lowered before continuing with tire calibration adjustment by using the Scan Tool. Return to the Diagnostic System Check procedure afterward.