When repairing the rear drive axle hub assembly the technician needs j 8092 j 2222-c j 24426 j 24427 j 44419 and j 44420 tools. Before working commence by suspending the vehicle and taking out the tire and wheel parts before uninstalling the brake caliper and
Axle Shaft. Take the j 2222-c to detach the axle nut retaining ring, key, and adjusting nut. Subsequently pull off the adjusting nut and hub from the axle housing and unzip the rotor when needed. A special seal-removal tool should be used to take out the Wheel Hub oil seal and then you should remove the inner hub bearing and its cup using a brass drift and hammer. Push out the Wheel Hub's retaining ring and then take away the outer hub bearing and bearing cup through j 24426 and j 8092. Apply ep-bearings lubrication to both bearings inside and outside wheel hubs along with their cups and axle housing. Push the Wheel Hub cup between the j 44419 and j 8092 before inserting the outer bearing and cup into the Wheel Hub. Screw the inner bearing cup into place with the j 24427 and j 8092 tools as the retaining ring sits fully in its groove. The j 44420 and j 8092 tools are needed to put in both the inner bearing and oil seal. Replacing the oil seal during this step safeguards against leaks. Put back the rotor if needed then put axle housing lubricant onto spindle and fix Wheel Hub to axle housing. To install and set wheel bearings use tool j 2222-c to adjust the nut. Reassemble all the parts except for the axle lubricant which should be checked and added if required then gently set the vehicle down.