Q: How to replace the rear quarter window motor on GMC Envoy?
A: The first step to replacing the rear quarter window actuator is removing the interior trim panel behind it then detaching the electrical connection. Start by unscrewing the window hinge screw that supports the actuator arm before disconnecting it. Then remove the retaining nuts from the actuator and proceed to take it out. You should use a 2.0 mm (0.08 in) pin to fasten the window bracket to the window frame. After mounting the actuator on its studs apply retaining nuts then tighten them to 7 n.m (2 lb in). Connect the electrical connector . The window latch bracket requires pinning to the window frame before adjusting an existing actuator. The bellcrank should be placed at a 45-degree angle against the vertical edge of the window side sheet metal while using body side power window switches at the overhead console to achieve this position. Fasten the screw between the window bracket and actuator arm when the bellcrank arm shows a 45-degree alignment parallel to the sheet metal flange while the screw gets tightened to 5 n.m (44 lb in). Seal the operation of the body side window by taking off the bracket connected to the window frame pin then repair the rear interior trim panel.
Q: How to service the power window motor on GMC Jimmy?
A: Start servicing the power Window Motor by releasing the counterbalance spring tension because failure to do so can result in injuries from the regulator lift arm. Start by uninstalling the Window Regulator and follow it with drilling a hole through both the Window Regulator and sector gear before using a bolt and nut to lock the sector gear into position. The next step includes drilling the rivets which retain the power Window Motor (W0133-1620520) to the Window Regulator before removing the motor. To install the power Window Motor (W0133-1620520) connect it to the Window Regulator while you remove the bolt and nut which holds the sector gear. The installation concludes with the placement of the rivets which keep the power Window Motor attached to the Window Regulator before putting back the Window Regulator.
Q: How to replace the front side door window motor on GMC Canyon?
A: The process to replace front side door Window Regulator motors starts by tension release of counterbalance springs to prevent injuries from regulatory lift arms. The first procedure involves taking out the front door Window Regulator. Drill a hole through both components of the Window Regulator bracket and lift arm before fixing the lift arm with a nut and bolt through this opening while removing the motor component. Remove the front Window Regulator motor from the bracket by disconnecting its mounting bolts before taking it out. When installing the front Window Regulator motor users must follow the fastener notice instructions for correct fitting to the regulator. Install bolts to the regulator bracket where they should be tightened to 4.5 n.m (40 lb in). To complete the process reinstall the front Window Regulator on the front door after removing both the nut and bolt from the lift arm.