Other Name: Plate, Rear End Panel And Tailgate; Emblem, End Gate And Rear Door Decoration; Emblem,Rear End Panel And Tailgate; Plate,Rear End Panel And Tailgate
Position: Rear
Replaces: 10372469, 25739124, 25762472
Item Weight: 0.30 Pounds
Item Dimensions: 4.9 x 1.6 x 0.3 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 10387855
Warranty: This genuine part is guaranteed by GM's
factory warranty.
More Info
Fits the following 2007 Cadillac XLR Submodels:
Base, Platinum, V | 8 Cyl 4.4 L GAS, 8 Cyl 4.6 L GAS
Other Name: Emblem, Radiator Grille And Front End Ornamentation
Position: Front
Item Weight: 0.40 Pounds
Item Dimensions: 4.9 x 1.5 x 0.8 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 15233934
Warranty: This genuine part is guaranteed by GM's
factory warranty.
More Info
Fits the following 2007 Cadillac XLR Submodels:
V | 8 Cyl 4.4 L GAS
2007 Cadillac XLR Emblem
With a comprehensive array of OEM 2007 Cadillac XLR Emblem, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2007 Cadillac XLR Emblem are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.
2007 Cadillac XLR Parts Questions & Experts Answers
Q: How to replace the front fender emblem and nameplate on 2007 Cadillac XLR?
A: To replace the front fender emblem and nameplate, first, tape the surface of the mounting, use tape marks on installation. Heat the emblem/nameplate with a J 25070 Heat Gun (J 25070) using a circular pattern around the emblem/nameplate for approximately 30 seconds and hold the heat gun at about 1 ft. 5.25 in. (152 mm) away from the surface. This nameplate/emblem has to be delicately removed from the panel surface using a plastic, flat-bladed tool. Before installation, clean up the site using a lint-free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 solution of isopropyl alcohol and water, and dry it completely. In case the location is not marked, use the specified dimensions with the help of tape. for XLR emblem/nameplate on it which have to be placed 108 mm (4.25 in) from the trailing edge of the fender 305 mm (12 in) from the bottom edge of the fender) In case necessary, heat the mounting surface to about 27-41°C (80-105°F) with the J 25070 applying heat to the emblem/nameplate to about 29-32°C (85-90°F). Do not touch the adhesive backing, remove the liner included to the back of the emblem/nameplate. Place it relative to the marks and press it down onto the mounting surface with equal pressure to have a uniform bond. Finally, strip away the protective tape from the mounting surface.