Other Name: Plate, Rear End Panel And Tailgate; Emblem, End Gate And Rear Door Decoration; Emblem,Rear End Panel And Tailgate; Plate,Rear End Panel And Tailgate
Position: Rear
Replaces: 10372469, 25739124, 25762472
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2006-2009 Cadillac XLR | Base, Platinum, V | 8 Cyl 4.4 L GAS, 8 Cyl 4.6 L GAS
Other Name: Cap-Hub Polished 19" Wheels *Black Backgr; Wheel Center Cap; Hub Cap; Emblem; Emblem, Wheel Cover Appearance; Cap, Wheel - Front And Rear; Cap, Wheel Trim
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2006-2009 Cadillac XLR | Base, Platinum, V | 8 Cyl 4.4 L GAS, 8 Cyl 4.6 L GAS
Cadillac XLR Emblem
Our website offers an extensive catalog of genuine Cadillac XLR Emblem at unbeatable prices. Every OEM Cadillac XLR Emblem comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Cadillac XLR Emblem Parts Questions & Experts Answers
Q: How to replace the rear compartment lid emblem and nameplate on Cadillac XLR?
A: Before attaching the rear compartment lid parts put tape on the surface for protection and use tape to line up during the process. Heat the emblem/nameplate through the J 25070 (J 25070) movements for 30 seconds while keeping it 152 mm (6 inches) away from the surface. Use a plastic tool made of hard plastic to slowly pulls the emblem/nameplate through its adhesive layers from the panel surface. Heat the emblem/nameplate to temperatures between 85 and 90 F degrees (29 to 32 C degrees) and stay away from handling the adhesive side during the process. Place the emblem/nameplate on its mounting surface after removing protective backing and applying heat from J 25070 to approximately 27-41 C (80-105 F). Put the V8 Northstar emblem on the driver side at 67mm (2.6in) left and 86mm (3.4in) bottom from the rear compartment lid. Attach the XLR emblem to the passenger side at 60mm (2.4in) from the right edge while keeping it 86mm (3.4in) below the bottom edge of the lid. Press evenly over the emblem/nameplate to correctly attach it to the surface before removing the backing tape.