How to replace the front brake line on 2007 Chevrolet Express 2500?

Start work by lifting and holding the vehicle before taking off the wheel and tire. Wipe away debris from both brake hose and pipe ends before putting a rubber cap over the open brake pipe end to protect the system from fluid loss and contamination. Secure the brake hose with a back up wrench before taking off the brake pipe fitting. Place a cap or plug over the brake pipe fitting after separation. Free the rubber clip from the brake hose mounting bracket before removing first the bolt that holds the brake hose bracket on the upper Control Arm and Steering Knuckle. Unbolt and remove the brake hose to caliper bolt from the brake caliper while getting rid of the 2 copper brake hose gaskets. The assembly begins by placing brake hose bolt and gaskets on brake hose. After that install brake hose to caliper bolt and put brake caliper with two washers underneath. Torque the bolt to 44 n.m (32 lb ft) before verifying brake hose position and contact-free suspension elements. Thread the brake hose bracket bolt through the bracket and Steering Knuckle until it tightens properly at 10 n.m (88 lb in). Fit the brake hose into its bracket and install the retaining clip above it. Connect the brake pipe to the brake hose by placing the back up wrench onto the brake hose fitting end while staying clear of the mounting bracket and brake pipe and apply 25 n.m (18 lb ft) of torque. For proper installation, run fluid out of the hydraulic brakes before putting back the tire system. Keep the brake hose safely away from suspension parts and the tire during setup and check it during extreme wheel turns for damage. You should disconnect and repair the brake hose problem then test the system when the vehicle has been dropped to ground.

OEM 2007 Chevrolet Express 2500 Brake Line

Brake Hose

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

6 Brake Lines found

View related parts
2007 Chevrolet Express 2500 Flex Hose, Passenger Side
Part Number: 84286062
$20.48 MSRP: $38.44
You Save: $17.96 (47%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Hose, Hydraulic Brake; Hydraulic Hose; Brake Hose; Brake Line
- Position: Passenger Side
- Replaces: 15823478, 15102361, 22844597, 25756666, 15878723, 20803179
- Item Weight: 1.10 Pounds
- Item Dimensions: 19.9 x 4.7 x 2.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 84286062
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 Chevrolet Express 2500 Submodels:
- Base, LS, LT | 4 Cyl 2.8 L DIESEL, 6 Cyl 4.3 L FLEX, 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L FLEX, 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL, 8 Cyl 6.6 L GAS
View related parts
2007 Chevrolet Express 2500 Flex Hose, Front Passenger Side
Part Number: 84286064
$23.93 MSRP: $43.33
You Save: $19.40 (45%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Hose Assembly-Front Brake; Hydraulic Hose; Brake Hose; Brake Line
- Position: Front Passenger Side
- Replaces: 15823492, 23189414, 25752975, 20852862
- Item Weight: 1.20 Pounds
- Item Dimensions: 34.6 x 3.2 x 3.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 84286064
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 Chevrolet Express 2500 Submodels:
- Base, LS, LT | 4 Cyl 2.8 L DIESEL, 6 Cyl 4.3 L FLEX, 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L FLEX, 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL, 8 Cyl 6.6 L GAS
View related parts
2007 Chevrolet Express 2500 Flex Hose, Front Driver Side
Part Number: 84286063
$20.86 MSRP: $37.77
You Save: $16.91 (45%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Hose Assembly-Front Brake; Hydraulic Hose; Brake Hose; Brake Line
- Position: Front Driver Side
- Replaces: 15823493, 23189415, 25752976, 20852863
- Item Weight: 1.30 Pounds
- Item Dimensions: 34.7 x 3.1 x 3.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 84286063
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 Chevrolet Express 2500 Submodels:
- Base, LS, LT | 4 Cyl 2.8 L DIESEL, 6 Cyl 4.3 L FLEX, 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L FLEX, 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL, 8 Cyl 6.6 L GAS
View related parts
2007 Chevrolet Express 2500 Flex Hose, Rear Driver Side
Part Number: 19366777
$73.88 MSRP: $144.65
You Save: $70.77 (49%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Hose Assembly, Rear Brake; Hydraulic Hose; Brake Hose; Brake Line; Hose, Hydraulic Brake
- Position: Rear Driver Side
- Replaces: 15117109, 15878725, 20830366, 15823480
- Item Weight: 1.30 Pounds
- Item Dimensions: 5.1 x 3.0 x 20.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 19366777
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 Chevrolet Express 2500 Submodels:
- Base, LS, LT | 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L FLEX, 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL
View related parts
2007 Chevrolet Express 2500 Flex Hose, Front Passenger Side
Part Number: 19366787
$49.89 MSRP: $90.31
You Save: $40.42 (45%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Hose Assembly, Front Brake; Hydraulic Hose; Brake Hose; Brake Line; Hose, Hydraulic Brake
- Position: Front Passenger Side
- Replaces: 15823491, 20852861, 23189413
- Item Weight: 1.30 Pounds
- Item Dimensions: 4.2 x 31.8 x 2.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 19366787
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 Chevrolet Express 2500 Submodels:
- Base, LS, LT | 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L FLEX, 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL
View related parts
2007 Chevrolet Express 2500 Flex Hose, Front Driver Side
Part Number: 19366788
$46.85 MSRP: $87.99
You Save: $41.14 (47%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Hose Assembly, Front Brake; Hydraulic Hose; Brake Hose; Brake Line; Hose, Hydraulic Brake
- Position: Front Driver Side
- Replaces: 15823490, 20852864, 23189416
- Item Weight: 1.30 Pounds
- Item Dimensions: 4.1 x 31.5 x 2.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 19366788
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2007 Chevrolet Express 2500 Submodels:
- Base, LS, LT | 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L FLEX, 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL

2007 Chevrolet Express 2500 Brake Line

With a comprehensive array of OEM 2007 Chevrolet Express 2500 Brake Line, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2007 Chevrolet Express 2500 Brake Line are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2007 Chevrolet Express 2500 Brake Line Parts Questions & Experts Answers

Q: How to replace the front brake line on 2007 Chevrolet Express 2500?
A: Start work by lifting and holding the vehicle before taking off the wheel and tire. Wipe away debris from both brake hose and pipe ends before putting a rubber cap over the open brake pipe end to protect the system from fluid loss and contamination. Secure the brake hose with a back up wrench before taking off the brake pipe fitting. Place a cap or plug over the brake pipe fitting after separation. Free the rubber clip from the brake hose mounting bracket before removing first the bolt that holds the brake hose bracket on the upper Control Arm and Steering Knuckle. Unbolt and remove the brake hose to caliper bolt from the brake caliper while getting rid of the 2 copper brake hose gaskets. The assembly begins by placing brake hose bolt and gaskets on brake hose. After that install brake hose to caliper bolt and put brake caliper with two washers underneath. Torque the bolt to 44 n.m (32 lb ft) before verifying brake hose position and contact-free suspension elements. Thread the brake hose bracket bolt through the bracket and Steering Knuckle until it tightens properly at 10 n.m (88 lb in). Fit the brake hose into its bracket and install the retaining clip above it. Connect the brake pipe to the brake hose by placing the back up wrench onto the brake hose fitting end while staying clear of the mounting bracket and brake pipe and apply 25 n.m (18 lb ft) of torque. For proper installation, run fluid out of the hydraulic brakes before putting back the tire system. Keep the brake hose safely away from suspension parts and the tire during setup and check it during extreme wheel turns for damage. You should disconnect and repair the brake hose problem then test the system when the vehicle has been dropped to ground.