OEM Buick LeSabre Throttle Cable

Buick LeSabre Throttle Cable Parts and Q&A

• Throttle Cable
  25654686
  Q: How to Service and Repair the Throttle Cable on Buick LeSabre?

  A:

  The replacement process for the Throttle Cable begins by taking off the left closeout/insulator panel. To install the replacement of the Throttle Cable start by disconnecting it from the accelerator pedal lever. Then use the Throttle Cable cover tangs to compress and feed the cable through the bulkhead. The Throttle Cable requires removal in two locations. Start by removing it first from its retaining clip and then from the right position situated on top of the washer bottle. Separate the Throttle Cable segment first from the Throttle Body lever and then from the Throttle Cable bracket. The installation requires the Throttle Cable to pass through the bulkhead after which install the snap retainer. Guide the Throttle Cable into the slot of the accelerator pedal lever and validate when the cable fits properly with the accelerator pedal lever. The dash panel insulator must be attached to the Throttle Cable followed by pushing the retainer along the cable lever end fitting until it snaps onto the cable's dash fitting flange while resting flush against the dash mat. Open the throttle from wide open to full closed without cable resistance and operate the accelerator pedal to confirm full and complete throttle range by positioning the cable hook within the Throttle Body lever. Reinstall the Throttle Cable to the retaining clip while reattaching the left closeout/insulator panel after securing the Throttle Cable to the Throttle Cable bracket which fits to the right slot on top of the washer bottle.
• Cable
  25731925
  Q: How to replace the throttle cable on Buick LeSabre?

  A:

  The left ip accessory trim plate requires removal to begin Throttle Cable replacement. First disconnect the Throttle Cable from the accelerator pedal lever. Afterward push the Throttle Cable through the bulkhead by squeezing the Throttle Cable cover tangs. First disconnect the Throttle Cable through its retaining clip to unattach it from the Throttle Body lever and Throttle Cable bracket. Secure fasteners should be used to prevent interference when routing flexible components that are closer than 50 mm (2 in) to moving pans. Drive the Throttle Cable through the bulkhead before attaching it with the snap retainer. Slide the Throttle Cable through the slot on the accelerator pedal lever to enable both cable end fitting snaps to interact properly with the lever. Position the dash panel insulator retainer so it maintains appropriate contact with the Throttle Cable and dash mat. Through the passenger compartment push the retainer until it situates on the cable dash fitting flange and snaps the lever end fitting while ensuring the throttle moves with full freedom between closed and wide open positions. Complete throttle range availability should be checked through accelerator pedal movements while examining the cable's position within the Throttle Body lever hook. Position the Throttle Cable onto the Throttle Body lever and connect it to the Throttle Cable bracket before stabilizing the Throttle Cable through the retaining clip followed by reinstalling the left ip accessory trim plate.