To replace the front shock absorber and spring assembly, first lift and support the vehicle, thereafter, remove one tire and wheel. Next, remove the upper
Control Arm to
Steering Knuckle pinch bolt and nut, but disconnect from the Steering Knuckle the upper Ball Joint. Take off the shock module lower mounting bolts and drop the vehicle. Remove the air conditioning line retaining nut from the shock tower and move the bracket for air conditioning line to the side, remove the upper mounting bolts of shock modules. Remove the shock module from the vehicle. For installation, reinstall the shock module back to the vehicle ensuring that one uses the right fasteners at their designated position, as replacement fasteners must own the right part. Number for the application. Sales phosphates, temperature potential, warns, peppers of its self-effects a form poloxate on fasteners unless situate. Mount the shock module upper in place by using the shock module upper mounting bolts and secure them with a torque of 112 nm (83 lb ft). Posi the bracket of the air conditioning line to the stud and install the retaining nut of the air conditioning line, then tighten it to 9 nm (80 lb in). Lift up the vehicle again, install the shock module lower mounting boles and tighten them to 25 nm18 lbft. Reconnect the upper Ball Joint on to the Steering Knuckle then install the upper Control Arm on to the Steering Knuckle pinch bolt and nut tightening the bolt to 60 nm (44 lb ft). Finally, degun, refit the tire and wheel, and lower the vehicle.