Other Name: Emblem, Radiator Grille And Front End Ornamentation; Emblem, Front Bumper
Position: Front
Replaces: 15199885
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2004-2012 Chevrolet Colorado | Base, LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
Other Name: Plate, Cab And Load Carrier Outer Side Decoration; Plate Assembly, Cab And Load Carrier Outer Side Decoration
Position: Outer
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2005-2008 Chevrolet Colorado | LS, LT, Sport, Sport LS, WT, Z71, Z71 LS, Z85, Z85 LS | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS
Other Name: Emblem Assembly-End Gate *Dark Blue; Emblem, End Gate And Rear Door Decoration; Emblem,Rear End Panel And Tailgate; Emblem, Body Side
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2018 Chevrolet Colorado | Base, LT, WT, Z71, ZR2 | 4 Cyl 2.5 L GAS, 4 Cyl 2.8 L DIESEL, 6 Cyl 3.6 L GAS
| Page 1 of 2 |Next >
1-20 of 24 Results
Chevrolet Colorado Emblem
Our website offers an extensive catalog of genuine Chevrolet Colorado Emblem at unbeatable prices. Every OEM Chevrolet Colorado Emblem comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Colorado Emblem Parts Questions & Experts Answers
Q: How to replace the endgate emblem/nameplate on Chevrolet Colorado?
A: To replace a Colorado endgate emblem/nameplate begin with these two items: Heat Gun (J 25070) and 3M(TM) scotch brite molding adhesive remover disk (3M(TM) P/N 07501). Start your procedure by laying down protective tape around both sides of the tailgate emblem. Set the 152 mm long Heat Gun (J 25070) away from the emblem at 6 inches and move it in circles toward the emblem/nameplate for 30 seconds to heat it. When removing the endgate emblem you need to first dislodge it with a plastic blade before treating all remaining adhesive residues with a special 3M adhesive removal material on both parts. Wipe the tailgate flat with VMP naptha cleaning solution. Use tape and measure two inches 61mm from the tailgate edge and 2.61 inches 66.4mm from below to set the appropriate location. Apply heat from the Heat Gun (J 25070) to bring the tailgate surface to 21°C (70°F) minimum without touching the emblem/nameplate adhesive backing. Press the front part of the emblem/nameplate onto the target position on the tailgate as you pull off the remaining backing. Press and roll the emblem/nameplate by hand to secure it properly then check for good binding before removing backing tape from around the emblem.