Q: How to replace the Leaf Spring Shackle on a Chevrolet Colorado?
A: The process to replace a spring shackle starts by lifting and securing the vehicle followed by supporting the rear axle at its normal height. Begin by unscrewing the shackle nut and bolt that attaches the frame to the vehicle and then remove the same pieces from the shackle assembly on the spring. Once accomplished pull out both pieces from the vehicle. Mount the shackle assembly to the spring after making sure to fasten the shackle nut and bolt onto the spring before torqueing them to 85 nm (63 lb ft). The technician should mount the shackle nut and bolt to the frame before tightening it to 85 nm (63 lb ft). Finally, drop the vehicle while removing the rear axle support. The special tool j 36660-a angle meter should be used throughout this procedure.
Q: How to service and repair the Leaf Spring Shackle on Chevrolet Express 3500?
A: Service and repair of the shackle begins by elevating the vehicle to a hoist then using a suitable jack stand to stabilize the rear axle as this allows the rear springs to relax. First disconnect the tire and wheel before taking out both retaining bolts from the shackle assembly. Next remove the shackle from the vehicle. Install the shackle on the vehicle by first placing it back in position then tightening a new lower retaining bolt with new nut followed by tightening a new upper retaining bolt with another new nut until both reach a torque level of 90 nm (67 ft. Lbs.). After properly resetting the tire and wheel you must lower the vehicle.
Q: How to replace the Leaf Spring Shackle on Chevrolet Silverado 1500?
A: Your first step to replace the spring shackle starts with vehicle raising and support. Start by lifting the vehicle and then taking out its leaf spring assembly. The spring shackle installation starts by removing its shackle nut along with bolt. The shackle installation requires mounting it onto the spring by following the Fastener Notice directions. Secure the spring shackles with the provided bolts and nuts by tightening them to 95 N.m (70 lb ft). Reinstalling the leaf spring assembly onto the vehicle should be followed by safety stand removal and vehicle lowering.