To remove the negative Battery Cable of the v6 engine, the client should first detach the negative Battery Cable. Take off the air cleaner outlet resonator, then remove the engine wiring harness electrical connector from the battery current sensor. Remove the battery current sensor clip from battery tray and lift and support the vehicle. If there are, take off the oil pan skid plate and bolts. Then, remove the negative Battery Cable bolt, from the front of the engine block and relocate the negative Battery Cable terminal", engine wiring harness terminal, under the case from the engine block and remove the forward lamp wiring harness ground bolt, and terminal from the frame". Pull the terminal of the negative Battery Cable through the opening between the radiator support and frame, and remove the negative Battery Cable clip from the vehicle chassis harness and clip away from the right wheelhouse liner before you pull out the negative Battery Cable from the vehicle. In case to change a negative Battery Cable, remove the battery current sensor. In case the negative Battery Cable is replaced, install battery current sensor. Wearing gloves, install the negative Battery Cable to the vehicle and negative Battery Cable clip to the right wheelhouse liner. Lift and support the ride, and then connect the negative Battery Cable clip over to the chassis harness and route out the negative Battery Cable through the gap between the radiator support and frame putting it behind the forward lamp harness. Install the froward lamp wiring harness terminal to the frame with tab inserted into the hole in the frame, the forward lamp wiring harness ground bolt become 25 nm (18 lb ft). Position the terminal of the engine wiring harness against the engine block and lay the negative cable of the battery across it up. Attach the negative Battery Cable bolt to the front of the engine block and tighten it to 25 nm (18 lb ft). Don't do anything if it is not applicable. Add the position of the oil pan skid plate and convert the bolts, tighten them to 28 nm (21 lb ft). Lower the vehicle, install the battery current sensor clip to the battery tray, connect the engine wiring harness electric connector to the battery current sensor and install the air cleaner outlet resonator before use the negative Battery Cable.