The process of serving and repairing the Throttle Body requires that the spot which is to be repaired is disconnected from its negative cable, engine cover, air cleaner outlet duct, and air cleaner outlet duct adapter stud removed. Then, take off the cruise control cable and accelerator cable and then remove the stud and the nuts that hold the accelerator control cable bracket in place and put the bracket to the side. Relocate the iac valve harness connector and the tp sensor harness connector, then remove the Throttle Body retaining studs and the Throttle Body assembly, which needs to be discarded and included with the Throttle Body seal. For installation, clean the gasket surface of
Intake Manifold and install Throttle Body assembly with new seal while the Throttle Body assembly retaining studs need to be tightened to 9 n. M (80 lb in). Install air cleaner outlet duct adapter stud by tightening it to 8 n.m (72 lb in); link tp sensor and the iac valve harness connectors. Replace the accelerator control cable the engine using the fasteners in a 12n.m (108 lb in) turn, make sure the accelerator and cruise control cables do not keep the throttle arms opened. Proceed to install the accelerator cable, cruise control cable etc and air cleaner outlet duct and the engine cover, then reconnect the negative
Battery Cable. Finally, inspect the accelerator pedal operation by pressing to the floor and releasing and ensuring it moves freely without binding between full and closed throttle.