Make sure this part fits

GM 25750065
Pull Handle, Driver Side

2003-2016 GM

Customer Questions & Expert Answers (28)
GM 25750065 Pull Handle, Driver Side
GM 25750065 Pull Handle, Driver Side
  • Part Description
    Handle, Door Trim/Access
  • Position
    Driver Side
  • Manufacturer
    General Motors
Make sure this part fits
$30.22 MSRP: $44.98
You Save: $14.76 (33%)
Currently Unavailable

Due to manufacturer supply shortage, this item isn't currently available for ordering.

  • Vehicle Fitment

    Year Make Model Trim Engine
    2003-2014 Chevrolet Express 1500Base, LS, LT6 Cyl 4.3 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
    2003-2016 Chevrolet Express 2500Base, LS, LT6 Cyl 4.3 L GAS, 8 Cyl 4.8 L FLEX, 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL
    2003-2016 Chevrolet Express 3500Base, LS, LT8 Cyl 4.8 L FLEX, 8 Cyl 4.8 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL
    2003-2014 GMC Savana 1500Base, LS, LT, SLE6 Cyl 4.3 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
    2003-2016 GMC Savana 2500Base, LS, LT, SLE6 Cyl 4.3 L GAS, 8 Cyl 4.8 L FLEX, 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL
    2003-2016 GMC Savana 3500Base, LS, LT, SLE8 Cyl 4.8 L FLEX, 8 Cyl 4.8 L GAS, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL
    Warning: California's Proposition 65
  • Customer Questions & Expert Answers

    Q:
    Can you help me check if this 25750065 is the right part for my car? Posted by ChevyPartsGiant Specialist
    A:
    Please Select Your Vehicle model to see if part number 25750065 is suitable before ordering.
    Posted by ChevyPartsGiant Specialist
    Q:
    What is the first step to service and repair the front door interior handle for the 2005 Chevrolet Express 2500? Posted by Customer
    A:
    Begin by pressing the retaining tab on the inside door handle bezel to release it from the front door trim plate.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What is the final step in the installation process for the 2006 Chevrolet Express 1500? Posted by Customer
    A:
    Secure the handle by installing the rivet at the rear edge and reinstall the right side rear door trim panel.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What needs to be disconnected after detaching the handle for the 2004 Chevrolet Express 1500? Posted by Customer
    A:
    Disconnect the lock rods from the handle and fully remove the handle.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    How do you remove the outside door handle for the 2006 Chevrolet Express 1500? Posted by Customer
    A:
    After removing the nuts and bracket, you can take out the handle.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What is the first step to replace the front door interior handle for the 2006 Chevrolet Express 3500? Posted by Customer
    A:
    First, remove the front door trim panel and the front door water deflector.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What should be installed after the lock rods for the 2008 Chevrolet Express 2500? Posted by Customer
    A:
    Reinstall the water deflector.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What is the first step to replace the sliding door inside handle for the 2006 Chevrolet Express 2500? Posted by Customer
    A:
    Use the Door Handle Clip Remover (J 9886-01) to release the retaining clip on the sliding side door inside handle.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What should be done after removing the rivets for the 2008 Chevrolet Express 2500? Posted by Customer
    A:
    Take out the inside door handle from the door inner panel, followed by the removal of the lock rod and door handle rod from the inside door handle.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What is the first step in the installation process for the 2010 Chevrolet Express 3500? Posted by Customer
    A:
    Place the sliding side door inside handle back into the vehicle.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What do you do after removing the nuts and bracket for the 2004 Chevrolet Express 1500? Posted by Customer
    A:
    Take out the outside door handle.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What should be done after removing the trim panel for the 2007 Chevrolet Express 3500? Posted by Customer
    A:
    Take out the rivet located at the rear edge of the rear door inside handle and slide the handle forward to detach it from the right rear door.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What is the final step after securing the assembly for the 2008 Chevrolet Express 3500? Posted by Customer
    A:
    Reattach the lock rods to the lock and reinstall the right side rear door trim panel.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    How do you ensure the handle is properly engaged for the 2009 Chevrolet Express 3500? Posted by Customer
    A:
    Align the tabs on the handle with the slots in the door, then slide the handle rearward to engage it properly.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    How do you access the nuts securing the outside door handle for the 2009 GMC Savana 2500? Posted by Customer
    A:
    Lift upward on the rear run channel.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What is the next step after disconnecting the lock rods for the 2006 GMC Savana 2500? Posted by Customer
    A:
    Remove the nuts and the bracket that secure the outside door handle to the sliding side door.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What is the first step to replace the sliding door inside handle for the 2007 GMC Savana 3500? Posted by Customer
    A:
    Use the Door Handle Clip Remover (J 988601) to release the retaining clip on the sliding side door inside handle.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What is the proper torque for tightening the nuts for the 2010 GMC Savana 1500? Posted by Customer
    A:
    Tighten the nuts to 11 Nm (97 lb in).
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What should be removed to secure the outside door handle for the 2007 GMC Savana 2500? Posted by Customer
    A:
    The nuts and bracket that secure the outside door handle to the sliding side door.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    How do you remove the assembly for the 2006 GMC Savana 3500? Posted by Customer
    A:
    Carefully take out the assembly, which includes the anti-theft shield, from the right rear door.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What is the first step to replace the front door interior handle for the 2004 GMC Savana 1500? Posted by Customer
    A:
    First, remove the front door trim panel and the front door water deflector.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What should be detached next for the 2005 GMC Savana 2500? Posted by Customer
    A:
    Detach the nuts and the bracket that secure the outside door handle to the sliding side door.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What should be done after removing the lower trim panel for the 2010 GMC Savana 1500? Posted by Customer
    A:
    Take out the sliding side door control assembly.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    How do you install the new latch handle for the 2003 GMC Savana 3500? Posted by Customer
    A:
    Position the new latch handle onto the door and secure it with the nuts, tightening them to 11 N.m (97 lb in).
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What is the first step to replace the sliding door inside handle for the 2009 GMC Savana 1500? Posted by Customer
    A:
    Use the Door Handle Clip Remover (J 9886-01) to release the retaining clip on the sliding side door inside handle.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What should be done after releasing the retaining clip for the 2005 GMC Savana 3500? Posted by Customer
    A:
    Remove the inside handle from the sliding side door control assembly and then take it out of the vehicle.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    What is the installation process for the outside door handle for the 2007 GMC Savana 3500? Posted by Customer
    A:
    Position the outside door handle back onto the door and secure it with the nuts and bracket.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    Q:
    How do you remove the assembly for the 2004 GMC Savana 3500? Posted by Customer
    A:
    Carefully take out the assembly, which includes the anti-theft shield, from the right rear door.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Handle
    If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

OEM GM Pull Handle, Driver Side 25750065 Designed for Proper Fit and Performance

Original OEM GM parts deliver superior quality and meet all performance standards needed for optimal automotive operation. The authentic part identified by 25750065 Pull Handle, Driver Side is available in the market under the name GM Door Handle. This genuine product has a full warranty coverage from the manufacturer available at all authorized GM dealers throughout the United States. This part 25750065 Pull Handle, Driver Side fits certain Chevrolet Express 1500, Express 2500, Express 3500 models, as well as GMC Savana 2500, Savana 3500, Savana 1500 models.
The original GM component designated by manufacturer part number 25750065 maintains top performance when functioning as the Handle, Door Trim/Access unit at its Driver Side. The component 25750065 is constructed from durable material and its dimensions span 5.1 x 5.0 x 24.7 inches while weighing 0.40 Pounds. The Direct Replacement component is ready in New condition to ensure full compatibility with your vehicle system. The part 25750065 has available replacement options. GM manufacturer provides a warranty that ensures reliable operation of this product. The Shipping Policy and Return Policy pages outline complete details regarding shipping procedures and return processes.
If you want to save money in the long run on maintenance and repairs, you should choose OEM products because they're of the top level of durability. Are you on the quest of finding GM parts, our site is worth a visit. We stock an endless selection of high-quality GM components including things like ignition coils all the way through to fan shrouds and all at prices that can not be matched. You have nothing to worry about because all our OEM parts are covered with a manufacturer warranty, which guarantees superior quality and value.