Other Name: SEAL Rear Wheel Bearing Oil; Axle Seals; Seal, Rear Wheel Bearing Oil
Position: Rear
Fits the following Chevrolet Models:
Silverado 2500 HD | 2011-2024 | Custom, High Country, LT, LTZ, WT | 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL, 8 Cyl 6.6 L FLEX, 8 Cyl 6.6 L GAS
Silverado 3500 HD | 2011-2024 | High Country, LT, LTZ, WT | 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS, 8 Cyl 6.6 L DIESEL, 8 Cyl 6.6 L FLEX, 8 Cyl 6.6 L GAS
Suburban 3500 HD | 2016-2019 | LS, LT | 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS
Q: How to replace the front drive axle wheel seal and bearing on Chevrolet Colorado?
A: The first step to replace front drive axle components involves removing the wheel drive shaft together with the swaybar link from the lower Control Arm. The isolation operation requires the bushing and bearing remover (J 29369-2) together with the slide hammer (J 2619-01) until the axle seal removal is complete. Both tools must then be used to separate the axle bearing from its installation place. Install the axle bearing inside the intermediate housing through use of differential bearing adjuster needle bearing installer - left (J 45232) together with universal drive handle 3/4 inch - 10 (J 8092). The extension housing seal installer (J 21426) enables the installation of the axle seal. The last installation steps include putting back the wheel drive shaft and swaybar link on the lower Control Arm before checking fluid level and letting the vehicle down.
Q: How to replace the right rear axle wheel seal on Chevrolet Equinox?
A: The first step to replace right rear axle shaft seal involves supporting the vehicle at its elevated position while draining the rear Differential fluid. The exhaust system and spare tire should be removed while moving the propeller shaft to the vehicle side and securing it with mechanics wire but leaving it attached. Support the rear Differential using a transmission jack while you proceed to remove both the propeller shaft and right rear wheel drive shaft. You need to first lower the Differential by taking out the right rear Differential support bushing bolt, left Differential mount and right Differential support bushing nut before reaching the axle shaft seal. Apply the j 8092 driver handle together with j 33832 rear bearing installer to detach the axle shaft seal. To put in the new axle shaft seal you should mount the j 8092 onto the j 33832 then apply this tool combination to perform installation. Put the Differential in position inside the rear cradle and put on the left rear support bolt followed by the right Differential support bushing nut and left Differential mount . After removing the transmission jack stand you must reinstate the right rear wheel drive shaft in addition to the propeller shaft and exhaust system. Put the spare tire back into position while completing the desired fluid amount in the rear Differential.
Q: How to replace the outer rear axle wheel seal on Chevrolet Tahoe?
A: Proper lifting equipment enables the replacement of the outer rear Axle Shaft seal. The first step is to remove the tire and wheel assembly while subsequent steps include removing both the Axle Shaft. One must extract the Axle Shaft seal after completing the previous steps. Start the installation procedure by putting the new Axle Shaft seal into place and reinstall the Axle Shaft with its tire and wheel assembly. To finish this process you should lower the vehicle.