GM 15056576
Pull Handle

Start the replacement of the front door interior handle by taking out the right side interior trim of the rear door. First disconnect the rivet at the rear edge of the rear door inside handle before sliding the handle forward to separate it from the right rear door. Slide off the handle by disconnecting its lock rods before complete removal. Place the new rear door inside handle onto the right rear door before you attach the lock rods to its mounting position. Once the handle tabs reach the door slots you should push the handle back to lock the assembly correctly. Secure the handle by fastening a rivet at the rear edge before putting back the right side rear door trim panel.

Position the outside door handle back onto the door and secure it with the bracket and nuts.

Carefully take out the assembly, which includes the anti-theft shield, from the right rear door.

Align the inside door handle bezel with the front door trim plate and press it towards the door trim panel to engage the retaining tab.

Place the sliding side door inside handle back into the vehicle.

Take out the water deflector and remove the lock rods from the lock.

Remove the right side rear door trim panel.

Install the rivet at the rear edge and reinstall the right side rear door trim panel.

Detach the lock rods from the lock.

Disconnect the lock rods from the handle and fully remove it.

Reinstall the water deflector and finally, put the door trim panel back in place.

Install the rivet to secure the inside door handle, followed by the water deflector.

Take out the push pin rivet located at the rear edge of the rear door inside handle.

Remove the right side rear door trim panel.

Reinstall the rear run channel, then attach the lock rods to the lock.

Press on the sliding side door inside handle to engage the retaining clip.

Finally, reinstall the door trim panel.

Place the sliding side door inside handle back into the vehicle.

Remove the front door trim panel and then take out the water deflector.

Disconnect the lock rods from the side rear door latch handle.

Position the new handle onto the right rear door and attach the lock rods to it.

Take off the nuts and the bracket that secure the outside door handle to the door, allowing you to remove the handle.

Install the nuts and bracket, tightening the retaining nuts to 11 N.m (97 lb in).

The nuts and the bracket that secure the outside door handle to the sliding side door.

Remove the sliding door lower trim panel.

Position the new handle onto the door and install the nuts and bracket to secure it, tightening them to 11 Nm (97 lb in).

Take out the outside door handle.

Press on the sliding side door inside handle to engage the retaining clip securely.

Attach the lock rods to the inside door handle.

Position the right side rear door outside door handle and license pocket assembly onto the right rear door, ensuring the anti-theft shield is placed between the assembly and the door.

Attach it to the control assembly.

Tighten them to 11 Nm (97 lb in).

Reattach the lock rods to the lock, reinstall the sliding side door control assembly, and finally, put back the sliding door lower trim panel.

Position the inside door handle bezel onto the vehicle.

Detach the lock rods from the lock and remove the nuts securing the right side rear door outside door handle and license pocket assembly.