Q: How to remove and install the cruise control module on Chevrolet Camaro?
A: To remove the Cruise Control Module, in case the car does not have traction control, rotate the throttle lever rearward, pushing down the cable end to disengage it from the throttle lever pin as well as use the flat bladed tool to push in the cable retainer of the crash Throttle Body bracket and slide the cruise control cable up from the Throttle Body bracket and hold the retainer and cable off the car. If equipped with traction control, unsnap and remove cruise control servo cable adjuster cover, rotate upper cam and remove cruise control cable slug from servo cable adjuster, then come out and unsnap locking tab and remove sled from slot. Place the Throttle Body end of the cruise control cable close to the Cruise Control Module, lift and support the car, take left front bumper fascia lower deflector off and then unfasten the Cruise Control Module bracket bolts. Next, you will need to remove the Cruise Control Module and bracket from the left side engine compartment outer rail and unsnap its cover, remove the electrical connector retainer and then remove the Cruise Control Module electrical connector and unbolt the cable locking retainer from the module. Compress the conduit tangs and pull out the cruise control cable from the module and unhook the cable bead from the module ribbon and place the module and bracket on a work surface. Take out the Cruise Control Module to bracket bolts to remove the module from the bracket. For installation, fix the Cruise Control Module onto the bracket through fixing the Cruise Control Module bolts and tightening the bolts to 5 n.m (44 lb in). Check the cable end to confirm the o-ring is present, pull the Throttle Body end of the cable until taut connecting the cable bead to the module ribbon rotating the cable end if required straightening the ribbon,shove the cable fitting end over the ribbon snap in the cable end to the module and the assure the conduit western tangs are in use. Insert the cable locking retainer over the module, hook the Cruise Control Module electrical connector, and install the electrical connector retainer. Position the Cruise Control Module cover over the cable and bracket by snapping on the cover to the flanges on the bracket install the Cruise Control Module and bracket to the lhs engine compartment outer rail and tighten the Cruise Control Module bracket bolts to the rail to 10 n. M (89 lb in) and the bracket bolt to 2 n.m (18 lb in). Pull the Throttle Body end of cruise control cable to the Throttle Body. Install left front bumper fascia lower deflector, and lower the vehicle. If equipped with traction control, spin the upper cad and install the cruise control cable slug to the servo not work adjuster, plane the cruise control cabin at coffer sled to the slot and make sure the hindering tag is pulled to thigh, and push down the cruise come master's servo copper inflict cover and push it down and snap into position. If not provided with traction control, push the throttle lever rearward, break the end of the cruise control cable to the throttle lever, align the cable, slide it on the slot with the locking tab pulled in, and adjust the cruise control cable to the desired length.