Other Name: Blower Motor Resistor; Resistor, A/C Electric Temperature And Motor Control; Resistor, A/C Evaporator Blower; Resistor, Heater Blower Motor
Fits the following Buick Models:
Century | 1990-1991 | Custom, Limited, Special | 4 Cyl 2.5 L GAS, 6 Cyl 3.3 L GAS
Q: How to replace the blower motor resistor on Buick Century?
A: Before installing the new Blower Motor Resistor you need to disconnect the battery negative cable and take off the right side instrument panel insulator. Take away both electric wire connections from the Blower Motor Resistor and the Blower Motor itself. The Blower Motor Resistor opening has a restricted area so loosen its front bolts but leave them in place before you detach the rearward bolt and remove the Blower Motor Resistor. Install the new Blower Motor Resistor into place then bolt down its rear component with 1.5 n.m torque. Set the new Blower Motor Resistor into place before fastening both forward bolts at 1.5 n.m (13 lb in). Link the Blower Motor and electrical resistor connections back to their places and put the right side instrument panel insulator in position before reconnecting the negative Battery Cable.
Q: How to replace the blower motor resistor assembly on Buick Rendezvous?
A: Begin the Blower Motor Resistor assembly replacement task by taking off the right side instrument panel insulator followed by disconnecting the Blower Motor electrical connector. Take the Blower Motor out of its position by removing all its mounting screws. Before continuing work on the Blower Motor Resistor assembly, free only the forward screws by loosening their mounting screws as the slots on the holes permit limited movement. You can take out the Blower Motor Resistor assembly from its hvac position by unscrewing the rearward blower resistor assembly mount. Put the Blower Motor Resistor assembly inside the hvac module assembly and fasten it with the rearward blower resistor assembly screw before tightening all screws to 1.8 n.m (16 lb in). Use the electrical connector to join with the Blower Motor Resistor assembly and fix the Blower Motor into its place within the hvac module assembly by tightening its mounting screws to 1.8 n.m (16 lb in). Connect the Blower Motor electrical connector before replacing the right side instrument panel insulator.
Q: How to replace the blower motor resistor assembly on Buick Regal?
A: Start by taking out the right side instrument panel insulator before changing the Blower Motor resistor assembly. Disconnect the electrical wiring from the Blower Motor resistor and motor while remembering that the Blower Motor resistor has a narrow slot to access its internal components. Remove the forward screws of the front resistor and both screws from the rear resistor before removing the entire Blower Motor resistor. Position the forward retaining slots of the Blower Motor resistor onto screws and place the motor control processor correctly onto the hvac housing to install. Put in the Blower Motor resistor and fasten its rear screw to 1.5 n.m (13 lb in) tension while putting and clamping the forward Blower Motor resistor screws with the same force. Reconnect the electrical components to both the Blower Motor and motor resistor before placing back the right side instrument panel insulator.