Q: How to replace the Engine Coolant Fan Shroud (LLV, LLR) (2.9L, 3.7L) on GMC Canyon?
A: The first step for Fan Shroud replacement of the engine coolant Fan Shroud (LLV, LLR) (2.9L, 3.7L) is to remove the Radiator Hose-outlet. Begin by unhooking the retainer which secures the differential vent hose before unlatching both a/c suction and discharge hose retainers. Use counterclockwise motion to rotate the slip ring away from under the Fan Shroud before taking out the Fan Shroud . Place the Fan Shroud correctly on the vehicle body then turn the slip ring to where it started before moving on with installation. The installation requires reattaching the differential vent hose retainer followed by the a/c suction hose retainer and finally the Radiator Hose-outlet together with the a/c discharge hose retainer.
Q: How to replace the Fan Shroud (Mechanical) in the Engine Coolant Lower Section on GMC Yukon?
A: Start the replacement of the engine coolant fan lower shroud (Mechanical) by taking out the cooling fan first. The procedure for replacing engine coolant fan lower shroud (Mechanical) requires owners to detach the oil cooler hose clip if their vehicle has this option from the lower Fan Shroud. The second step requires raising the lower Fan Shroud until all retaining clips at the Radiator are freed. Installation starts with positioning the lower Fan Shroud at the center of the lower Radiator support before reinstalling the oil cooler hose clip when an Engine Oil Cooler is present. Finally, reinstall the cooling fan.
Q: How to replace the Mechanical Fan Shroud Lower Section on GMC Sierra 1500?
A: The first step for replacement of the engine coolant fan lower shroud (Mechanical) requires removal of the Radiator following standard replacement procedures. The next step requires users to detach the two clips holding the Radiator into position. The lower Fan Shroud should be equipped with an Engine Oil Cooler hose clip which must be removed from its position. Next disassemble and take away the shroud unit from the automobile. Set the lower Fan Shroud into position by placing it at Radiator support center then connect the Radiator's two clips. For vehicles with engine oil coolers one should install the oil cooler hose clip to the lower Fan Shroud. Installation requires the complete following of replacement procedures for the Radiator.