Make sure this part fits

GM 16636579
Lock, Rear Driver Side

1995-2005 GM

Customer Questions & Expert Answers (17)
GM 16636579 Lock, Rear Driver Side
GM 16636579 Lock, Rear Driver Side
  • Part Description
    Latch Sub Assembly-Rear Door Service None; Door Lock Actuator Motor; Door Latch Assembly; Trunk Latch; Door Lock
  • Position
    Rear Driver Side
  • Replaces
    16629717
  • Manufacturer
    General Motors
  • Manufacturer's Notes
    This part is discontinued.
Make sure this part fits
  • Vehicle Fitment

    Year Make Model Trim Engine
    1997-2005 Buick CenturyCustom, Limited, Special Edition6 Cyl 3.1 L GAS
    1997-2004 Buick Regal25th Anniversary Edition, GS, GSE, LS, LSE6 Cyl 3.8 L GAS
    1995-2001 Chevrolet LuminaBase, LS, LTZ6 Cyl 3.1 L GAS, 6 Cyl 3.4 L GAS, 6 Cyl 3.8 L GAS
    1995-1999 Chevrolet Monte CarloIndianapolis 500 Pace Car, LS, Z346 Cyl 3.1 L GAS, 6 Cyl 3.4 L GAS, 6 Cyl 3.8 L GAS
    1998-2002 Oldsmobile IntrigueBase, GL, GLS, GX6 Cyl 3.5 L GAS, 6 Cyl 3.8 L GAS
    2001-2004 Pontiac AztekBase, GT, Rally6 Cyl 3.4 L GAS
    1997-2003 Pontiac Grand PrixGT, GTP, SE6 Cyl 3.1 L GAS, 6 Cyl 3.8 L GAS
    Warning: California's Proposition 65
  • Customer Questions & Expert Answers

    Q:
    Is this 16636579 designed for my car? Posted by ChevyPartsGiant Specialist
    A:
    Please Select Your Vehicle model to see if part number 16636579 is suitable before ordering.
    Posted by ChevyPartsGiant Specialist
    Q:
    How do you remove the push-in retainers from the latch for the 2000 Buick Regal? Posted by Customer
    A:
    Use the Door Trim Pad and Garnish Clip Remover (J 38778).
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Trunk Latch
    Q:
    What should be done after positioning the outside door handle rod for the 2002 Buick Century? Posted by Customer
    A:
    Close the clip cover over the threaded outside door handle rod.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Lock
    Q:
    What is the first step to replace the rear side door lock actuator for the 2001 Buick Century? Posted by Customer
    A:
    Remove the rear door lock.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Lock Actuator
    Q:
    What is the torque specification for tightening the screws for the 2002 Buick Century? Posted by Customer
    A:
    Tighten them to 2 N.m (18 lb in).
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Lock Actuator
    Q:
    How should the actuator be secured for the 2005 Buick Century? Posted by Customer
    A:
    Secure the actuator with screws, tightening them to 2 Nm (18 lb in).
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Lock Actuator
    Q:
    How do you remove the rear compartment lid latch for the 2005 Buick Century? Posted by Customer
    A:
    Remove the nuts securing the rear compartment lid latch to the rear compartment lid and take out the latch.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Trunk Latch
    Q:
    How do you install the new front door lock actuator for the 2005 Buick Century? Posted by Customer
    A:
    Position the new front door lock actuator onto the front door lock and ensure to follow the fastener notice for proper guidance.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Lock Actuator
    Q:
    What is the torque specification for tightening the screws for the 2002 Buick Regal? Posted by Customer
    A:
    Tighten them to 2 N.m (18 lb in).
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Lock Actuator
    Q:
    What should be done after marking the latch's location for the 2003 Buick Century? Posted by Customer
    A:
    Disconnect the electrical connectors from the latch and the lock cylinder actuator cable from the lock cylinder.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Trunk Latch
    Q:
    What is the next step after removing the screws for the 2000 Buick Regal? Posted by Customer
    A:
    Detach the rear door actuator from the rear door lock.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Lock Actuator
    Q:
    What should be done after removing the front door lock for the 2003 Buick Century? Posted by Customer
    A:
    Take out the screws securing the front door lock actuator and detach it from the front door lock.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Lock Actuator
    Q:
    What is the installation process for the new rear compartment lid latch for the 2001 Buick Regal? Posted by Customer
    A:
    Position the new rear compartment lid latch according to the alignment marks on the rear compartment lid, then install the nuts and tighten them to 10 N.m (89 lb in).
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Trunk Latch
    Q:
    What should be done after removing the trim panel and water deflector for the 2002 Buick Regal? Posted by Customer
    A:
    Next, detach the inside handle rods from the handle and remove the clip securing them to the door.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Lock
    Q:
    What should be done after removing the front door lock for the 2000 Buick Regal? Posted by Customer
    A:
    Take out the screws securing the front door lock to the front door lock actuator.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Lock Actuator
    Q:
    How do you install the new rear door lock actuator for the 2004 Buick Regal? Posted by Customer
    A:
    Position the new rear door lock actuator onto the rear door lock, ensuring to follow the Fastener Notice for proper guidance.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Door Lock Actuator
    Q:
    What is the final step after installing the latch for the 2000 Chevrolet Lumina? Posted by Customer
    A:
    Install the rear compartment latch actuator and close the rear compartment.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Trunk Latch
    If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

OEM GM Lock, Rear Driver Side 16636579 Designed for Proper Fit and Performance

Original OEM GM parts deliver superior quality and meet all performance standards needed for optimal automotive operation. The authentic part identified by 16636579 Lock, Rear Driver Side is available in the market under the name GM Door Lock, Door Lock Actuator, Tailgate Latch, Tailgate Lock, Trunk Latch, Door Latch Assembly. This genuine product has a full warranty coverage from the manufacturer available at all authorized GM dealers throughout the United States. This part 16636579 Lock, Rear Driver Side fits certain Chevrolet Lumina, Monte Carlo models, as well as Buick Regal, Century. Additionally, it is compatible with Pontiac Grand Prix, Aztek and Oldsmobile Intrigue models.
The original GM component designated by manufacturer part number 16636579 maintains top performance when functioning as the Latch Sub Assembly-Rear Door Service None; Door Lock Actuator Motor; Door Latch Assembly; Trunk Latch; Door Lock unit at its Rear Driver Side. The component 16636579 is constructed from durable material and its dimensions span 8.1 x 4.8 x 4.5 inches while weighing 1.60 Pounds. The Direct Replacement component is ready in New condition to ensure full compatibility with your vehicle system. This component receives the designation of Latch; Latch, Rear Compartment Lid Or Tail Gate Latch; Latch, Rear Side Door. The part 16636579 has available replacement options 16629717. GM manufacturer provides a warranty that ensures reliable operation of this product. The Shipping Policy and Return Policy pages outline complete details regarding shipping procedures and return processes.
If you want to save money in the long run on maintenance and repairs, you should choose OEM products because they're of the top level of durability. Are you on the quest of finding GM parts, our site is worth a visit. We stock an endless selection of high-quality GM components including things like ignition coils all the way through to fan shrouds and all at prices that can not be matched. You have nothing to worry about because all our OEM parts are covered with a manufacturer warranty, which guarantees superior quality and value.