Q: How to replace the Motor and Transmission Mount on a 2WD on Chevrolet Colorado?
A: First, raise and support the vehicle where the transmission mount for a 2WD vehicle are to be changed. With the help of a transmission jack, support the transmission, take off the 2 nuts fasten the transmission mount to the transmission support. Before disconnecting, lift the transmission off the support and remove the four transmission mount bolts including transmission mount and transmission mount spacer bolts. Second, remove the transmission mount spacer. Step one for installation, and install the transmission mount spacer followed by the spacer bolts. Subsequently, install the transmission mount and remember to tighten up the four bolts to 55 N.m (41 lb ft). Lower the transmission and secure it with the installation of the 2 nuts on the transmission mount to tighten them on 57 N.m (42 lb. ft.). Finally, slide out the transmission jack and drop the vehicle.
Q: How to replace the Motor and Transmission Mount on the NV 1500 on Chevrolet S10?
A: The transmission mount on nv 1500 requires replacement by lifting and supporting the vehicle before implementing a transmission jack to support the transmission. Moving on to the replacement process begin by undoing the transmission support retaining nut which allows the transmission to rise up off its weight-bearing mount. The replacement process starts by raising the transmission just enough to remove the transmission mount from the vehicle after bolting off the transmission mounting bolts. Reinstall the transmission mount into its proper position within the vehicle before tightening the transmission mounting bolts to 45 nm for 2.2l equipped vehicles while using 50 nm for 4.3l vehicles. Put the transmission mount into the transmission support retaining nut before tightening it to 57 nm (42 ft. Lbs.). You should lower the vehicle while removing the transmission jack.
Q: How to replace the Motor and Transmission Mount on a 4L80-E/4L85-E on Chevrolet Tahoe?
A: The first step for changing the 4l80-e/4l85-e transmission mount requires vehicle liftering and support while using a transmission jack to sustain the transmission. Lifting the transmission enables relief of mounting force by removing transmission support retaining nuts. You should start by removing the transmission mount's bolts from the adapter connections to both the transmission and transfer case. Then elevate the transmission just enough to pull the mount free from its position. Mount the transmission mount into its designated vehicle position then bolt it to the transmission or transfer case adapter mounting points and tighten bolts to 50 nm (37 ft. Lbs.). Place the transmission mount onto the transmission support and tighten retaining nuts or bolts at 40 nm (30 ft. Lbs.). Use the transmission jack to remove it then lower the vehicle down.